COMPLIANCE INFO 2010 - 2011 - Laserfiche WebLink

Home Browse Search

San Joaquin County Environmental Health Department DIRECTOR 600 East Main Street Donna Heran, REHS Stockton, California 95202-3029 PROGRAM COORDINATORS . ' Robert McClellon,REHS Jeff Carruesco,REHS, RDI ,. �P Kasey Foley,REHS Website: www.sjgov.org/ehd Linda Turkatte,REHS 2011 Phone: (209)468-3420 Fax: (209)464.0138 Scott Covey Covey Engineering Inc 985 Kendall Drive, Suite A-151 San Bernandio, CA 92407 Re: YRC Inc SR0061778 1535 East Pescadero Ave, Tracy, CA 95376 Revised The San Joaquin County Environmental Health Department (EHD) has completed the review of the application for a permit to perform the following repairs on the underground storage tank (UST) system at the above noted address: Install a pull annular sensor on the T-4 gear oil tank by removing the stuck push annular sensor by breaking concrete and removing the riser on the T-4 gear oil tank. Replace the T-5 motor oil annular sensor. Verify the placement position for: annular sensors on tanks T-3 antifreeze, T-4 gear oil, T-5 motor oil, and T-6 waste oil and liquid detection sump sensor for L-2 diesel and L-14 waste oil. Repairs will made to the T-6 waste oil tank to by removing the stuck pull wrap around annular sensor by breaking concrete, removing the riser on the waste oil tank and if needed, install a new annular sensor. Installation on the waste oil tank will include: 12" capped vapor manway, a 5 gallon spill bucket and a new drop tube, if needed. Each tank, T-3 antifreeze, T-4 gear oil, T-5 motor oil and T-6 waste oil, have a tank level gauge that is set at 90% overfill and 95% high product as their overfill prevention method in conjunction with their mechanical flapper. A four-relay module will be installed in the monitoring panel programmed with the tank level gauge to function with an overfill alarm and acknowledgement device, installed in the bay truck shop, to provide audible and visual alarm. The approved permit has been revised with the following conditions: 1. Contact the local fire department and the San Joaquin Valley Air Pollution Control District for any applicable permits and requirements. 2. Any changes in information and scope of work must be submitted to EHD for approval prior to commencing work. All new addenda supersede the previous ones. 3. All components must be certified by an independent testing organization and labeled as required by the organization (UL, ULC, ANSI, API, ASTM, etc.). See California Code of Regulations (CCR)Title 23, Chapter 16, Table B for a complete list.