COMPLIANCE INFO 2012-2015 - Laserfiche WebLink

Home Browse Search

STEP 26: INSTALL WARNING PLATE CAUTION: Do not insert any foreign object(s) GENERAL INSTRUCTIONS property damage, fire, explosion, and water and Install warning plate around the 4" inch riser pipe into the drop tube if the flapper is in the The EBW 708-49X-1Y Series Overfill soil pollution. below the threaded portion using the stainless closed position. For example a tank level Prevention Valve and drop tube(EBW Make sure all connections, including the steel band clamp. measuring stick. This will damage the valve Autolimiter II) is designed for tight fill hose and elbow connections between the and void the Warranty. ALWAYS check the connections, gravity drop applications only, and storage tank and transport are securely valve position before "sticking" the tank. If to provide positive shut-off of product delivery valve is in the closed position the tank is before an overfill condition occurs without coupled. Prefer the use of rotatable Fill and Vapor adaptors. either over filled and you need to wait until the intervention from the transport driver(per EPA liquid level goes down or the EBW Auto and State requirements). The valve features a . Make sure the lip seal and/or all gaskets in Limiter II° is damaged and needs to be sealed float pivot and a threaded lower tube the delivery elbows and adaptors are r= replaced. connection with a maximum vapor leak rate of properly in place to prevent spills. 0.17CFH @ 2" inches H2O or less in �� EBW Auto Limiter II° Performance accordance with GARB TP-201.1 C or D. For • Do not make a delivery using damaged or Specifications: GARB EVR installations the Overfill Prevention missing parts, which prevent tight This Overfill Prevention Valve was manufactured by Valve and Drop Tube are installed below the connections. FFS and has been tested by FFS to meet the spill container drain valve in the underground storage tank (UST) in place of a standard Normal Operation of the over-fill valve: A Hose following specifications: "The maximum leak rate straight drop tube. "Kick" and reduced flow signal that the tank has �``-�, does not exceed 0.17 CFH at 2.00" inches W.C. reached 92% full. Fuel flow is reduced by 90%. when tested in accordance with CARB TP-201.1 C Close the transport delivery valve(s) and drain or D. The EBW Auto Limiter if is designed to be installed in the 4" inch riser pipe of a UST to hose into tank before discohn6btir g any hose reduce the flow by 90% (at approximately 92% fitting. If delivery is not stopped and the liquid Important: Leave these installation instructions of tank capacity) and shut the flow off at 95% rises above 95% of tank capacity the EBW and maintenance procedures with the station tank capacity. After the valve has been Auto Limiter I I valve will shut down the flow of operator. activated, the delivery hose can be drained. fuel into the UST. Figure 4 Construction The EBW Auto Limiter II° is designed to be inability to drain the hose STEP 27: VALVE REMOVAL Valve Body: Anodized Cast Aluminum or failure of the hose 6o� /rain after closidg the Upper Drop Tube: Aluminum i installed with a Phil-Tite Spill Container, and pp p delivery valve(s) signals an overfilled tank. Do The Over-fill prevention valve can be removed MIF 4 X 4 riser adaptor using Phil-Tite Lower Drop Tube: Aluminum installation instructions, work sheet, torque Not Disconnect any delivery hose fittings until from the tank by removing the Swivel Adaptor and Flappers: Die Cast Zinc and Acetal adapters and Flaring T-6100-F the liquid level in the tank has been lowered to Spill Container. Reinstall per the above p g Tool ( �' allow the hose to drain into the tank. instructions. Float: Polyethylene IMPORTANT Attention: In the event you are splashed with Step 28: Electronic Liquid Level Monitoring Models Read these assembly and installation fuel, remove all wetted clothing immediately. Part Description instructions completely and carefully prior to Do not go into an enclosed area and stay'away If an electronic level monitor is installed, it must starting. Check to make sure you have the from any and all ignition sources. be calibrated to match the top of the EBW Auto Dual point, 5'top tube, 8' bottom 708-491-01 tube special drop tube seal (85039-DT) and a Limiter ll®valve body, correlated to the 95% tank package of JB KWIK. Do not use any IMPORTANT level dimension used during assembly. Dual point, 5 tap tube, 10 bottom 708-491-02 tube substitutes for these items. The use of Determine if the underground storage,tank Dual point, 10' top tube, 8' bottom substitute parts may cause product failure. - PREVENTATIVE MAINTENANCE is equipped with a ball float vent valve.' In 708-492-01 tube all systems, the shut-off point.of the EBW, E The EBW Auto Limiter Il® 708 series is Dual point, 10'top tube, 10' bottom Failure to follow these instructions may cause Auto Limiter I1®must be reached before the maintenance free. Be sure to fill out the EVR 708-492-02 tube improper product operation or premature ball float reduces flow to ensure proper Equipment Warranty form (F-8352) and send CARB Approved, Dual point, 5' top failures which may permit storage tank overfill. overfill valve operation. See,CA State Water in to FFSIPhil-Tite within 30 days of 708-491-11 tube, 8' bottom tube An overfilled storage tank may create Resources Control Board Local Guidance y CARE Approved, Dual point, 5' to hazardous conditions and/or environmental installation. Failure #o do so will void the pp p p contamination. Letter LG-150-1 at: warranty. Annual visual inspection of the installed 708-491-12 tube, 10' bottom tube httpalwww.waterboards.ca.govlust/leak- CARB Approved, Dual point, 10'top drop tube for remnants of broken dip sticks or WARNING prevention/lgslindex.htmi or call (916) 341 - 708-492-11 tube, 8' bottom tube 5752 or (916) 341 - 5782. visual damage is recommended. Repairs must be CARB Approved, Dual paint, 10' top Failure to properly connect delivery hose and performed by certified individuals, 708-492-12 tube, 10' bottom tube elbow, and/or disconnecting a liquid filled delivery hose or elbow will result in a hazardous spill, which may result in personal injury, 2 it