Laserfiche WebLink
F) Adhesive Seal with Boot - Final Step <br /> You can only proceed with this step after all of your F-Series Fitting Installations have passed the <br /> interstitial test and there are no leaks. Your ROBROY or galvanized conduit must be absolutely <br /> clean and dry. Your Boot should already be over your conduit on the outside of the Sump. <br /> You will now seal your Boot to the conduit and F-Series fitting. <br /> FOR BOOT INSTALLATION, USE ONLY BRAVO PART <br /> NUMBER "ADHESIVE-KIT-FS-10" CARTRIDGE <br /> F After all of your <br /> F-Series Fittings have Fig. F1 <br /> been fully Installed and <br /> have passed the interstitial 77 Generously coat <br /> test with no leaks, FS-10 Adhesive <br /> Shoot minimum 20ml Here 360° Around <br /> Slide your exterior boot of Adhesive in boot / <br /> close to the fitting and / <br /> ensure the surfaces shown <br /> (FIG F1) are Clean and <br /> dry. Use Acetone to clean <br /> these surfaces. <br /> Prepare your - I~— 2 —~I <br /> ADHESIVE-KIT-FS-10 — <br /> adhesive cartridge into the <br /> MAN-GUN-FS-10 gun and <br /> apply adhesive 2" from the \ <br /> front of the fiberglass <br /> fitting and over the outer <br /> Diameter 3600 around as <br /> shown. (FIG F1) Fig. F2 Bead FS-10 <br /> Then inject a minimum of Adhesive with <br /> 20ml of FS-10 adhesive gloved finger <br /> into the Boot. (FIG F1) Tighten Clamps <br /> right after boot is <br /> F.2) After FS-10 adhesive slid over the fitting _ <br /> has been applied as shown <br /> in Figure F1, Slide the boot =_ <br /> over the exterior of the = <br /> Fiberglass Fitting. Tighten = =_ <br /> the hose clamps and bead = <br /> the FS-10 adhesive that Lim <br /> oozes out with a gloved <br /> finger (FIG F2). Let cure. <br /> 12 ii-F-Series-1 X-SS-D-09A <br />