Laserfiche WebLink
_ D. Alternate construction for new underground storage tanks containing motor vehicles fuel [Section 26331. <br /> (1) Monitoring and response plan [Section 26342. <br /> (2) Underground storage tank composed of.... <br /> (a) Fiberglass reinforced plastic. <br /> _ (b) Cathodically protected steel. <br /> (c) Steel clad with fiberglass reinforced plastic. <br /> _ (d) Other material that complies with section 2631 and 2632. <br /> --�—(3) Floor of leak interception and detection system constructed on a firm base and sloped to a <br /> collection sump (use of membrane Liners comply with section 2631 (d) (6) requirements.) <br /> �- (4) Access casings installed in the collection sump of the secondary containment system with <br /> backfill in the interstitial space. The access casing shall meet all of the following: <br /> _ Designed and installed to allow the liquid to flow into the casing. <br /> _ Sized to allow removal of collected liquid and able to withstand all anticipated applied <br /> stresses. <br /> _ Constructed of material that will not be structurally weakened. <br /> _ Screened along entire vertical zone of permeable material. <br /> _ Capable of preventing leakage of any hazardous substance from the casing. <br /> Extend to the ground surface and covered with a Locked waterproof cap. <br /> _ Capable of meeting S.J. Co. PHS-EHD well Standards. <br /> _ Leak interception and detection system shall prevent the Leaked hazardous substance from <br /> entering ground water. <br /> 14. INTERSTITIAL SPACE MONITORING <br /> A. Visual monitoring [Section 2632 (c) (1)] <br /> (a) Exterior surface and floor beneath tank monitored by direct viewing <br /> _ (b) Daily visual inspections <br /> _ (c) Liquid Level in tank to be recorded at time of inspection <br /> _ (d) If Liquid observed around or beneath primary tank, owner will determine if an unauthorized release <br /> has occurred. <br /> 8. Mechanical or electronic monitoring (Section 2632 (c) (2)1 <br /> �- (a) Continuous monitoring system connected to an audible and visual alarm system. <br /> Monitoring equipment to be installed p � L /� <br /> Manufacturer: ��P-2cllR.R- 1`s'v`I ©4� • f� <br /> _ Model Number: <br /> Sensor Type: Vapor Liquid _ Both. <br /> Sensor/Panel specifications. <br /> _ Location(s) for sensors: <br /> Tank: PIC Piping: <br /> Dispenser: <br /> C. Monitoring and response plan submitted [Section 2632 (d) (1) & (2)]. <br /> t <br /> 15. Any special accessories, fittings, coatings, or linings not inherent within the initial design of the 10 tank or <br /> double-wall UST. [Section 2631 (b)] <br /> A. Approved by a nationally recognized independent testing organization. <br /> B. Demonstration of integrity with the primary and/or secondary containment. <br /> 6 <br />