COMPLIANCE INFO_PRE 2019 - Laserfiche WebLink

Home Browse Search

Spill Prevention Compliance Corporation P.O. Box 1289........ Waterford, CA 95386 Telephone: (209) 969-0851 Email: spccorpa,hotmai1.com Website: www.spcplan.com Certified Assessment Form (PE) for AST Systems Assessor: Spill Prevention Compliance Corporation Onsite Assessor: Todd McWhorter P.O. Box 1289 Telephone: (209) 969-0851 Waterford, CA 95386 email: specorp(a),hotmail.com ------------------------------------------------------------------------------------------------------------------------------ Client: Stockton Hyundai Contact Person: Andy McCue, Service Manager Address: 2979 Auto Center Cir. 2nd Contact: City/State/Zip: Stockton, CA 95212 Date of Test: 9-22-15 ------------------------------------------------------------------------------------------------------------------------------- Assessment Data- Waste Oil AST —a 1. AST Configuration & age of AST Horizontal AST Single wall steel/approx.15 yrs, old ( estimate ) Ia. Useful Life Remaining of AST Approximately 15 years of remaining life (Subsection k1 -k10) 2. AST Primary vessel construction (describe) 570gals/Waste Oil/UL# 402905 /UL142-Container/ Made to UL 142 construction standard -at least .123in. steel thickness per UL Std, 3. AST piping (describe) 1 in galvanized and painted piping from Graco Husky 1040 Pump to 2 in opening w/fittinE. from pump for supply to top of AST. 4. Internal/External pump description external Graco Husky 1040 pump w/2 solenoid 12volt-10-200psi— External pump, which pumps waste oil from service areas (see Pic) 5. AST drawing (provided/drawn: source) (see attached) 6. Design Standard (ASMI~;, UL, etc.) UL 142 -Cylindrical Single Wall Steel /Mfr: ACE Tank 7. AST foundation (describe) concrete berm sub -floor, Base of AST under UL 142 adequate to withstand the load of a full tank -Tank is anchored to floor 8. AST anchoring (seismic zone/floatation risk) AST is anchored to the floor slab with 3/8 in. diameter expansion anchors into the concrete berm floor. Stockton is in a (ground -shaking) seismic region, but the AST is unlikely to move outside the room in an event nor pose a risk of flotation in such an event. The AST is situated in secured lubricants room. 9. AST will withstand frost -heave XX Yes No AST sits in concrete cinder block berm 10. AST previously relocated? Yes XX No 11. AST Corrosion Protection Tank is completely covered in paint, without evidence of corrosion. Tank has no specific corrosion protection beyond the paint No part of the AST touches the wound. The base of the AST is steel, raising the AST 1 inch above the floor. There is no evidence of corrosion taking place, however there is debris beneath AST which should be removed. Tank's construction material is carbon steel. 12. AST Spill Prevention Equipment AST has product is placed into AST via pumping from external Graco Husky Pump Product generaRv not handled outside of its intended containers. Product removal occurs via pumping out thru a 2 plugged opening in top of AST 13. Overfill Protection: AST sits in concrete berm with a Sentry product level alarm in the berm. This alarm was tested and found to be operatine. The sound was minimal, and indicative that the batteries in the Alarm should be changed AST has Krueger level gauge to indicate product levels in AST.