Laserfiche WebLink
6-151.01 SCOPE OF WORK <br />Page 11 of 13 <br />Furnish and install complete electrical system as shown on plans incl <br />conductor, equipment, connections and installation of all Owner furnished all conduits, <br />equipment. <br />1. Completelectrical system for submersible turbine pwnps including all sub-punp <br />relays emergency shut off. <br />1W <br />2. <br />3. <br />4. <br />Complete electrical, systems for tank leak detection and monitoring. <br />Conduit for future tank level sensor and card/key system. <br />Dispenser control wiring and electrical. <br />I <br />STANDARDS AND CODES: <br />1. Materials, workmanship'and testing shall conform to standards of NEMA, IEEE <br />NFPA, and USAIA. , <br />2. Standards of the National Board of Fire Underwriters as set forth in the <br />National Eelctrical Code, NFPA 70. <br />3. Title 24, Part 3, of the California Administrative Code. Rules and Regulations <br />of the California State Fire Marshal and California State Division of Industrial <br />Safety. <br />3. TESTS: The system as a whole shall be given a final full load test with all motors <br />and equipment in operation.. Any equipment shown defective in testing shall be <br />replaced by CDNnWTOR without additional cost to the Owner. The test shall be made <br />in the presence of the Engineer or his authorized representative and shall be to his <br />entire satisfaction. <br />=• MATERIALS: All materials delivered to the job shall be new, best quality of their <br />respective grades, packed in their original containers. <br />1. CONDUIT AND FITTINGS: <br />1. Conduit manufactured under supervision of UL Factory Inspection and <br />Label Service, with UL label and manufacturer's name on each length of <br />quit. <br />2. Fl=w: conform to same requirements as conduit, except as specified <br />herein. <br />b. RIGID STEEL CONDUIT: <br />1. Standard weight, threaded, zinc coated on outside by hot dipping, <br />sherardizing or metallizing process, with protective finish coating on <br />outside and inside. <br />2. FITTINGS: Threaded type, steel or malleable iron; set screw type or <br />threadless type not acceptable. <br />6.22 <br />