COMPLIANCE INFO 2006 - 2010 - Laserfiche WebLink

Home Browse Search

Sep 05 06 04: 24p JP PP+roleum Service 916372d073 p, 3 SB Series Pelletbane Split Repair Boots Installation Instructions For Encalnulation Repairs) STEP 1 Identify the damaged boot and seleet the proper Blueline Repair Boot based upon the number of studs and the pipe OD.(See 2006 Catalog,Section 10 and Appendix l) 7 AMP .i STEP 2 Install all Pellethane split components onto the pipe carefully.All — Pellethane pieces must be rebonded back together with Blue Seal Glue.This is done by ensuring that the surfaces are clean and dry. Apply a liberal bead of Blue Seal and hold the scam closed ill securely until it is fused. It's helpful to use the clamps to loosely i hold the boot closed during curing. Bonded connections should hold themselves closed within rive minutes if there are no stresses ^`j on them.The Blue Seal glue will be fully cured in 40 minutes. �. i. STEP 3 Once all Blueline approved components are bonded, apply a liberal bead of either Parasealant 626, or Bostik 110017S to the : underside of the seal.This will make the seal with the sump wall. l 1;Insert poly ring into the gasket and position the ring around the old fitting and against the sump wall. '\\' X STEP 4 Install the self tapping tek screws through the holes in the poly ring and tighten until snug.(Be careful not to over tighten as the holes can be easily stripped out.) , STEP 5 Apply a bead of Blue Seal Glue along the gasket rim and install the boot onto the seal. Install boot with rill tube at the 12.00 {:t^ position.Install band clamp to secure the boot to the gasket. CLUELINE TECHNOLOGIES LLC 265 Burns Drive. • :4: . .g