Laserfiche WebLink
"CONY Retrofit Plate" Kit Contents <br /> Contents: AUG 15 2017 <br /> (1) Pre-abraded Tank-spec FRP panel <br /> (1) Bravo Adhesive-Epoxy-Retrofit-Kit.,gVIRONMENTAL HEALTH <br /> (1) Stir stick [NOT SHOWN] DEPARTMENT <br /> (1) 1" chip (paint) brush <br /> (1) Emery sanding strip [NOT SHOWN] <br /> (1) Large pair nitrile gloves <br /> (1) NOTICE label <br /> (1) MSDS package [NOT SHOWN] <br /> FRP Plate material: <br /> UL Listed fiberglass (UL1316 matched) <br /> (Material MSDS included in package) <br /> The panel is technically the same as <br /> a piece of our CUL/US Listed SingleWall <br /> sump wall and is nominally 1/4" thick. <br /> NOTICE <br /> • • <br /> Image of the 1 <br /> NOTICE label THE FIBERGLASS RETROFIT PLATE(S) BONDED WITH EPDXY TO THIS <br /> CONV-62000 (UDSCCS) CONVERSION FRAME IS A STATE -AUTHORIZED <br /> MODIFICATION PROVIDED BYWAY OF THE PRODUCT INSTALLATION <br /> MANUAL AND MANUFACTURER CONTROL. REFER TO THIS PRODUCTS <br /> STATE APPROVAL LETTER AVAILABLE AT WWW.SBRAVO.COM / CONV <br /> STANDARD KIT SIZES <br /> Based on our evaluation of the specific application and site conditions, we have determined two <br /> standard kit sizes will apply to a majority of conduit interference issues. They are: <br /> CONV-Retrofit-Plate-6x18 6"x18" panel intended for the short ends of the conversion frame <br /> CONV-Retrofit-Plate-4x25 4"x25" panel Intended for the long sides of the conversion frame <br /> NOTE: Due to the custom nature of each custom conversion frame and application, the fiberglass <br /> panels in the CONV-Retrofit-Plate kit may require different dimensions than the sizes listed above. <br /> In this case the dimensions of the panel will change on the end of the part number. <br /> 2 ii-CONV-Retrofit-Plate-1213 - 9/24/2012 <br />