Laserfiche WebLink
17 <br />3a). Attach proper guide block to swage ram unit. An additional bushing is required for <br />female swivel type fittings. <br />3b). Insert draw bar through ram unit. <br />Remove Fitting Seal or Gasket <br />3c). Carefully oil or grease the inside of the piping termination. NOTE: Do not grease <br />inside of pipe or outside barbs of fittings !- <br />3d). Insert pipe termination thread first into guide block on ram unit. <br />3e). Screw swage mandrel onto draw bar and firmly against and partly within the <br />lubricated pipe termination fitting. <br />3f). Re -Grease or oil swage mandrel to insure a smooth swage draw cycle. <br />3g). Slide termination swage ferrule over termination fitting. <br />3h). Insert pipe onto termination fitting and inside swage ferrule. Pipe must be in at least <br />1 1/2" or until just visible through hole, if included, in swage ferrule. <br />3i). Pump hand pump or push button to draw swage mandrel through pipe termination. <br />3j). Release pump pressure and remove fitting. Re -Install Fitting Gasket or Seal. <br />4). Hand tighten swivel type fitting nut to "T" or 90 and wrench tighten no more than an <br />additional 1/2 turn. Do Not Exceed to prevent seal damage. <br />Swaging must be done in one complete action, do not stop once you have started. <br />