Laserfiche WebLink
D. Results of TestingServieinb <br />Software Version installed: ; �! <br />Complete the iollowinL eheekiist: <br />E T Dispatch <br />L: <br />Com. Yes �? No* Is the audible alarm or•erationai? <br />Yes ❑ No� is the visual alarm. operarional? <br />I <br />U Yes <br />Q No=` Were all sensors visually inspected. functionaliv tested. and confirmed onerationai? I <br />Z Yes <br />` <br />❑ Noy' <br />i <br />Were all sensors installed at lowest point of secondary containment and positioned so that other equipment will <br />not interfere with their proper operation? <br />-.E Yes <br />0 No* <br />If alarms are relayed to a remote monitoring station, is all communications equipment (e.g. modem) <br />❑ NIA <br />operational? <br />Yes <br />❑ No* <br />For pressurized piping systems, does the turbine automatically shut down if the piping secondary containment <br />❑ NIA <br />monitoring system detects a leak, fails to operate, or is electrically disconnected? If yes: which sensors initiate <br />positive shut -down? (Check all that apply) ;E1 Sump/Trench Sensors; "C 'Dispenser Containment Sensors. <br />Did you confi nr positive shut -down due to Seaks and sensor failure/disconnection? J�i-Yes; ❑ No. <br />ZI e%e <br />❑ No* <br />For tank systems that utilize the monitoring system as the primary tank overfill warning devicd (i.e. no <br />mechanical overfill prevention valve is installed), is the overfill wamin.g alarm visible and audible at the tank <br />1point(s) and operating properly? If so, at what percent of tank capacity does the alarm trigger? <br />Yes* <br />❑ No <br />Was any monitoring equipment replaced? If yes, identify specific sensors, probes, or other equipment replaced <br />and Iist the manufacturer name and model for all replacement parts in Section E. below. <br />Yes* <br />❑ No <br />Was liquid found inside any secondary containment systems designed as dry systems? (Check. all that apply) ❑ <br />Product; Water. If yes, describe causes in Section E, below. <br />Yes <br />❑ No* <br />Was monitoring system set-up reviewed to ensure Proper settings? Attach set u re orts, if applicable <br />' Yes <br />® No* <br />Is all monitoring equi went operational per manufacturer's specif cations? <br />` * In Section E below, describe how and when these deficiencies were or will be corrected. <br />Page 2 of 3 <br />