Laserfiche WebLink
Summary of I <br /> These steps are not a substitute for the detailed <br /> installation steps contained in the following pages. <br /> DO NOT ATTEMPT TO INSTALL THIS PRODUCT BASED <br /> ONLY ON THE SUMMARIZED STEPS LISTED ON THIS PAGE <br /> 1) Read the entire manual front to back, read carefully. Do not just view images. <br /> 2) Evaluate the sump, ensure sump material is FRP or steel, and the piping is FRP or conduit. <br /> 3) Remove any necessary components that will obstruct your access to the sump wall. <br /> Excavate adequate area on outside of all fittings you will install. <br /> 4) Clean each sump. Remove all contaminants, water and debris. Ensure each sump <br /> will be completely dry during all installation steps. <br /> 5) Secure conduit endpoints so they do not move or act as a lever. <br /> 6) Remove the interior boot and all of it's components or sealants from the wall and pipe. <br /> 7) Push existing bolts back into the backfill. Do not damage the sump wall doing this. <br /> 8) Properly protect the pipe or conduit against damage. <br /> 9) Abrade the interior of sump wall around hole until bare fiberglass is shown. <br /> 10) Clean, dry and rough up pipe or conduit surface in preparation for bonding. <br /> 11) Dust off all abraded surfaces with compressed air. <br /> 12) Dry-fit your fittings for clean fit against the wall and piping. Mark alignment stripe <br /> across the fitting halves and the sump wall with a permanent marker. <br /> 13) Bond split fitting to the interior of sump by manually pressing fitting halves <br /> firmly against the sump wall using hand strength. <br /> 14) Bead excess epoxy around primary seam at the wall and at the pipe. <br /> 15) Use acetone to clean the face of each fitting to look like a new install. Clamp halves <br /> together tight and re-clean any epoxy that oozes. <br /> 16) Allow epoxy to fully cure before testing fitting installation. Do not disturb while curing! <br /> 17) Mandatory Pressure/soap test to verify the fitting installation is good. <br /> 6 ii-F-Series-Retrofit-S-15A <br />