Laserfiche WebLink
STEP 3 (COMPLETE ❑ <br /> Before starting work, ensure all fuels <br /> Pushing back and flammables have been removed. <br /> existing bolts Testlmonitor your LEL's and ventilate. <br /> 1 <br /> Push the bolts back into the backfill. <br /> Most bolts move backwards easily. <br /> DO NOT DAMAGE THE SUMP WALL! <br /> 0 0 � <br /> Protect pipe Properly protect your piping from power <br /> ° q against any or sharp tools. DO NOT DAMAGE PIPE! <br /> damage <br /> STEP 4 CCOMPLETE ❑) <br /> Proceed to grind your walls clean of any <br /> 1 ABRADE paint, gel-coat, epoxies, adhesives or <br /> sealants until open fiberglass is clearly <br /> visible 3IN HE AWAY FROM THE <br /> HOLE, all the way around. <br /> WARNING! For steel sumps, you must <br /> be extremely careful about sparking <br /> when abrading. If the steel is epoxy <br /> 3" coated, it must be removed. You can only <br /> :. <br /> bond the Retrofit-S fitting to bare, clean <br /> „ ?y and abraded steel. <br /> STEP 5 COMPLETE ❑ <br /> SECURE ALL CONDUIT LINES BY <br /> STRIPE MARK BRACKETING THEM TO AT LEAST ONE <br /> ` mark across the <br /> RIGIDLY CONNECTED CONDUIT OR <br /> �- wall and all THE RISER. DO NOT ALLOW CONDUIT <br /> components <br /> ��...�- ENDPOINTS TO MOVE OR ACT AS A LEVER. <br /> FLAT WALLS: Dry fit the body on your pipe and <br /> use a marker to outline the fittings position on the <br /> wall. The curved flange will not be used. <br /> l DRY FIT CURVED WALLS: Dry fit the body and the curved <br /> ONLYflange and use a marker to mark a large stripe <br /> across the sump wall, body and flange. Also <br /> . -' outline the fittings position when dry fit. <br /> 8 ii-F-Series-Retrofit-S-15A <br />