Laserfiche WebLink
D. Results of Testing/Servicing, <br />Software Version Installed: <br />Complete the following checklist: <br />C E T Dispatch <br />Yes <br />0 No* <br />Is the audible alarm operational? <br />a'Yes <br />0 No* <br />Is the visual alarm operational? <br />J Yes <br />Er No* <br />Were all sensors visually inspected, functionally tested, and confirmed operational? <br />2—Yes <br />0 No* <br />Were all sensors installed at lowest point of secondary containment and positioned so that other equipment will <br />not interfere with their proper operation? <br />0 Yes <br />D No* <br />If alarms are relayed to a remote monitoring station, is all communications equipment (e.g. modem) <br />MI—N/A <br />operational? <br />Yes <br />0 No* <br />For pressurized piping systems, does the turbine automatically shut down if the piping secondary containment <br />0 N/A <br />monitoring system detects a leak, fails to operate, or is electrically disconnected? If yes: which sensors initiate <br />positive shut -down? (Check all that apply) ®'Sump/Trench Sensors; ®'Dispenser Containment Sensors. <br />Did you confirm positive shut -down due to'leaks and sensor failure/disconnection? ZI'Y`es; 0 No. <br />0 Yes <br />M'No* <br />For tank systems that utilize the monitoring system as the primary tank overfill warning device (i.e. no <br />0 N/A <br />mechanical overfill prevention valve is installed), is the overfill warning alarm visible and audible at the tank <br />fillpoint(s) and operating properly? If so, at what percent of tank capacity does the alarm trigger? % <br />Q'Yes* <br />E2 No <br />Was any monitoring equipment replaced? If yes, identify specific sensors, probes, or other equipment replaced <br />and list the manufacturer name and model for all replacement parts in Section E, below. <br />Yes* <br />U No <br />Was liquid found inside any secondary containment systems designed as dry systems? (Check all that apply) 0 <br />Product; ❑ Water. If yes, describe causes in Section E, below. <br />Yes <br />0 No* <br />Was monitoring system set-up reviewed to ensure proper settings? Attach set up reports, if applicable <br />R'Yes <br />0 No* <br />Is all monitoring equipment operational per manufacturer's specifications? <br />* In Semien E bciow, describe how ane y"'hes ttYe r- deficiencies were or V';M he <br />E. Comments: (1, 1, ^1 e <br />c-) <br />Page 2 of 3 <br />Y <br />