WORK PLANS - Laserfiche WebLink

Home Browse Search

IT CORPORATION Mr. J. Kelly Williamson Kayo Oil Company April 18, 1985 Page 2 Table 3 presents a simple model of the volume of soil that is contami- nated at each five-foot level under the site. It presents a worst case volume for the amount of gasoline in the sail of 84 gallons. This does not include the volume of gasoline in the soil between the 15 and and 35-foot levels, where we have no data. iowever, it does . not appear likely that the total contamination could be more than 100 gallons of gasoline. The laboratory report showing the BTX values used in the calculation is attached to this report. i METHOD FOR TOTAL PRODUCT CALCULATIONS A simplistic calculation of a worst case scenario to approximate the total volume of petroleum products in the oil at each of the sites was completed. The soils at each site were divided into zones five feet thick from the surface to the bottom of the borehole. Using the bore- hole data/LEL readings, the lateral exte t of contamination in each five-foot thick zone was delineated and the "surface" area of this zone approximated. Since each layer is five feet thick, the volume of con- taminated soil for each layer was then calculated by multiplying the "surface area" by 5. The volumes of the individual levels were then summed, and the worst case volume of hydr carbons present was calcula- ted. The total wet weight ,of the soil , assuming 12 percent moisture content, and then the total dry weight in kilograms was calculated. The highest hydrocarbon concentration (sum of xylene, benzene and toluene) for each site was used to calculate the amount of gasoline in the ground. Assum- ing a specific weight of approximately 0.6 /cc for the hydrocarbons and 998.6 kgm/cubic meter for water at 50°F, , he volume of gasoline in the soil was calculated. The calculations are recapped below; (TOTAL VOLUME OF DRY SOIL)*(125 LBS. PER CUBIC FOOT)= TOTAL UNIT WEIGHT (TOTAL UNIT WT)(0.454 kgm/lbs)(1)1.12-soil moisture 12%) = TOTAL DRY WEIGHT SOIL (TOTAL DRY WEIGHT SOIL) (TOTAL H OROCARBONS IN ppm) _ TOTAL HYDROCARBONS in mass (TOTAL HYDROCARBONS IN MASS)/(0. *998.6) _ TOTAL HYDROCARBON VOLUME in cubs meters i CONVERT CUBIC METERS TO LITERS Of HYDROCARBONS (TOTAL HYDROCARBONS in liters)(i) 3.78)= TOTAL HYDROCARBONS in gallons In addition, calculations were completed and are shown in graphical form, Plate 1, which shows the sensitiv ty of the final hydrocarbon