Laserfiche WebLink
TESTABLE PROCEDURE ONLY, FOR STANDARD MOD- <br />ELS, PROCEED TO NEXT PAGE, <br />STEP 1T: INSTALL SOCKET ADAPTOR ASSY <br />Put cable thru threads in inlet tube and out thru cable <br />port on side of inlet tube. Thread the socket adaptor <br />assembly finger tight into the inlet tube. Note: the ca- <br />ble port on the inlet tube must be in line with the float <br />STEP 3T: DETERMINE CABLE LENGTH <br />Run cable along upper tube and over the top plate on <br />the float bracket as shown. With the float in the down <br />position (as shown in Figure 3T) align loop in cable with <br />rivet and top hole in float bracket. Use the rivet as a <br />template to size the loop in the cable and pull cable <br />tight and crimp ferrule with crimping tool / pliers onto <br />cable at this location. Trim excess cable with wire cut- <br />as <br />shown previously in Figure 8A. t .r- -scissors. For reference, from the seam where the <br />Socket <br />adaptor <br />assembly <br />Figure 1 T <br />t��el tube and valve body meet to the end of the cable <br />attf't"rimming will require approximately 3.5 of cable. <br />Cable over float bracket <br />C <br />n <br />� �N-V\T P <br />J\�®�N <br />51 <br />Cable <br />port <br />STEP 2T: PASS CABLE THRU FERRULE <br />Pass cable thru ferrule. Loop cable and then pass cable <br />back thru ferrule. Keep ferrule loose until cable length <br />is determined in the next step. Note: if cable end frays <br />it may be necessary to trim the cable again to pass thru <br />ferrule. <br />Ferrule <br />Trim <br />cable � <br />after <br />step 3T Loop <br />Figure 2T <br />Se <br />Figure 3T <br />EP 4T: ATTACH <br />STCABLE TO FLOAT BRACKET <br />Ensure cable is over the float bracket. Using the sup- <br />plied rivet align loop in cable with top hole in float <br />bracket and pass rivet thru cable loop and float bracket <br />hole. Using rivet tool for 1/8" dia mandrel attach rivet <br />and cable to the float bracket. See last page for list of <br />replacement cable parts. <br />Figure <br />pole <br />STEP 5T: ENSURE PROPER CABLE OPERATION <br />Unthread the socket adaptor assembly from the inlet <br />tube and ensure float and poppet move freely when <br />socket adaptor assembly is pulled on. It should only <br />require 3" to 4" of movement in order to actuate the <br />at and poppet. Thread socket adaptor assembly fin- <br />ger tight into inlet tube after testing. <br />13 <br />