COMPLIANCE INFO 2013 - 2018 - Laserfiche WebLink

Home Browse Search

Installing Encore Island Adapter Kit Installing Encore Island Adapter Kit Encore Island Adapter Kit can be installed during an upgrade from a wide frame (48 -inch) The Advantage Series unit to an Encore unit. The Adapter Kit is required due to the difference in the footprint size of the units. The kit is installed after The Advantage unit has been removed and before the Encore unit is set into position. The adaptor may be painted to suit station requirements as stated in "Purpose" on page 1. Pit Box in the island must be altered to accommodate the Adapter Kit. To alter the Pit Box and install the Adapter Kit, proceed as follows: 1 Read all instructions in "Important Safety Information" on page 3 before beginning and observe all safety precautions during installation. 2 Ensure that all power has been removed from the installation area. For details on removing system power, refer to MDE-3893 Encore/Eclipse Owners Manual. 3 Locate the Encore Island Adapter Unit and 3M 2084 Sealant (END -1456) in the kit. 4 After the original dispensing unit is removed, the Pit Box is exposed. Observe that the Pit Box has a lip around the top perimeter that extends upward about 1 inch. This height extension may vary at each installation depending on the Pit Box type. 5 Position the Encore Island Adapter over the Pit Box. Note that the vertical protruding lip of the Pit Box is longer than the center opening in the Adapter. Center the Adapter on the existing Pit Box. 6 Using a marker, make required cut marks of approximately 5 millimeters (1/4 -inch) on the vertical Pit Box lip in four places (see Figure 1) inside the inner perimeter of the Adapter. Additional lip removal allows for clearance when installing the Adapter over the original Pit Box. 7 Remove the Island Adapter and set aside. Figure 1: Removing Existing Pit Box Area MDE-4166A The Advantaget Series Unit to Encore® Series Island Adapter Kit (M03064KO01) Installation Manual -March 2013 Page 5