Laserfiche WebLink
2. Drill <br />3. Hammer <br />4. Tape measure <br />5. Hacksaw or cut-off saw, fine tooth; 24 teeth/inch <br />6. Fine half round file <br />7. Screwdriver - Phillips blade <br />8. Fine grit sandpaper / steel wool <br />9. Grease, black moly <br />10. Torque Wrench <br />11. Band clamp (3-3/4" diameter minimum) <br />12. TESTABLE MODELS ONLY: rivet tool for 1 /8" man- <br />drel, crimping tool / pliers, wire cutter / scissors, <br />pipe dope, 1/4" square drive extension or 3/8" <br />square drive extension with 3/8" to 1/4" socket <br />adapter. <br />WARNING <br />Using electrically operated equipment near gasoline <br />or gasoline vapors may result in fire or explosion, <br />causing personal injury and property damage. <br />Check to assure the working area is free from such <br />hazards, and always use proper precautions. <br />IMPORTANT: The figures in this installation and <br />maintenance instruction may contain vapor recovery <br />equipment (including model numbers) that is not certi- <br />fied by the California Air Resources Board (CARB) for a <br />specific Phase I Vapor Recovery System. Please refer to <br />Exhibit 1 of the appropriate CARB Phase I Executive Or- <br />der for a list of certified Phase I Vapor Recovery System <br />Equipment. <br />71 SO Parts Diagram <br />Upper O -Ring Gasket <br />Screws, Qty 3 <br />Inlet Tube <br />Polypak Seal <br />Upper Drop Tube <br />e Body <br />=1oat <br />Lower O -Ring <br />Tube <br />Alternate Components -Testable Versions <br />Note: all components are the same except the <br />socket adaptor & cable assembly, rivet, testable <br />inlet tube, and ferrule. <br />Socket Adaptor &Cable <br />Assembly <br />Rivet <br />Ferrule <br />Testable Inlet <br />Tube _ <br />3 <br />