Laserfiche WebLink
5.2 ASSEMBLY OF LEGS TO PROCESSOR <br /> Please refer to FIGURE 5, the processor general arrangement drawing, for <br /> the following instructions. <br /> FIGURE 5: Processor FIGURE 6 <br /> (general arrangement) <br /> rWeather Cover SHELL <br /> Outer Shell <br /> Stack , <br /> t� Air bap <br /> PADLOCK <br /> BASE <br /> Vapor Feet <br /> peLEG <br /> Connection <br /> Ground level mount requires the use of the 48" Legs, and canopy or roof <br /> mount will require the 5" or longer Legs. If Legs not already purchased, see <br /> your local Hirt distributor. <br /> 5.2.1 Bolt appropriate Legs to Base of processor. Be sure to use the <br /> bolts, lock washers, and nuts provided with the Legs. Note that <br /> Legs attach behind corner angle brackets of Base, See FIGURE 6 <br /> for details. <br /> 5.2.2 Bolt feet to concrete, deck plate, and/or solid non-flammable <br /> structure. Note, concrete mount will require the use of (4) 1/4" DIA. <br /> X 3" RED HEAD wedge anchors (i.e. 2.5" embedment). <br /> WARNING: Do not block 1.5" air gap between processor Shell and Base. This <br /> gap allows combustion air to reach thermal oxidizer. Also, keep the <br /> processor area free and clear from combustibles, keep a minimum <br /> clearance of 2 ft. all the way around processor. <br /> Page 14-8 <br /> ARB Approved IOM-14—Hirt VCS 100 Processor Installation Manual—Executive Order VR-205-B <br />