Laserfiche WebLink
Page 2 of 3 <br /> This email/fax message is for the sole use of the intended recipients)and may contain confidential and privileged information.Any <br /> unauthorized review,use,disclosure or distribution of this emaillfax is prohibited. if you are not the intended recipient,please contact the <br /> sender by emaillfax and destroy all paper and electronic copies of the original message. <br /> From: Jack Peabody fmailto:JPeabody@Regenesis.com] <br /> Sent: Friday, August 12, 20114:44 PM <br /> To: Bill Little <br /> Cc: Brittain Griffiths <br /> Subject: FW: Sarale Farms at 16500 Clifton Court Road, Stockton, California <br /> Hi Bili <br /> Here is the questions on your project I got from the County. I will be on.vacation next week but Brittain Griffiths <br /> will be available if you folks need some help on this design. <br /> thanks <br /> Jack Peabody <br /> Ph: 925-944-5566 - Fax: 925-944-5625 <br /> From: Vicki McCartney [EH] [mailto:vmccartney@sjcehd.com] <br /> Sent: Friday, August 12, 20113:13 PM <br /> To: Jack Peabody <br /> Subject: Sarale Farms at 16500 Clifton Court Road, Stockton, California <br /> Jack: <br /> I spoke to you a few minutes ago concerning a site in Stockton where Advanced GeoEnviron mental, Inc. (AGE) <br /> proposes to perform a pilot test using RegenOx. The site is called Sarale Farms and it is located at 16500 Clifton <br /> Court Road, Stockton, California. You can review the work plan by going to the following internet site: <br /> httpsa/g eotracker.waterboards.ca.gov/ <br /> Once at this website, go to: Cleanup Sites by County <br /> Go to: San Joaquin County <br /> When you get to this place, organize the sites alphabetically by city. I believe Stockton begins on page 10 and <br /> continues through page 24. 1 found the Sarale Farms site on page 16. Click on this site, then go to Site <br /> Maps/Documents. It is here that you will find !n-situ Chemical Oxidation Pilot Test Work Plan, dated 24 June <br /> 2011. <br /> Please review Table 7. 1 believe the total RegenOx material AGE proposes to use is incorrect. I calculate the <br /> total reagent to be 2,430 pounds of RegenOx, not 9720 pounds. Will that be enough RegenOx? <br /> How do you determine the total amount of RegenOx to inject? How do you determine a five percent solution of <br /> RegenOx? <br /> The work plan does not propose performing an aquifer volume test prior to performing the pilot test. Is it <br /> appropriate to skip the aquifer volume test? <br /> look forward to hearing from you and I thank you for your time. <br /> Vicki McCartney, Senior REHS <br /> 8/15/2011 <br />