Laserfiche WebLink
ATY OF TAACP <br /> quality remains within the limits set by these criteria. As specified in the WDR's, PCB <br /> analyses are presented, and levels are well below those specified in Title 22 for <br /> hazardous wastes. <br /> Sludge treatment meets standards for a process to significantly reduce pathogens. Sludge <br /> has been air-dried on underdrained, sand drying beds since October, 1992, for over three <br /> months. This included the summer months, when temperatures are well in excess of the <br /> stipulated 2 months at 0 degrees C. <br /> Loading Rates and Calculations(2) <br /> Sludge loading calculation methods are detailed in Table 4. Agronomic rates of sludge <br /> are calculated by matching the crop nitrogen requirement with a sludge load that will <br /> provide the amount of available nitrogen during the year after the sludge is applied. This <br /> quantity of sludge specifies loading rates for other nutrients and heavy metals. <br /> Considered in the calculations are <br /> Nitrogen transformations, including mineralization, nitrification, <br /> denitrification, and ammonia volatilization <br /> Sludge properties, such as moisture content, density, and sand <br /> content (from sand drying bed floors) <br /> Analytical results for this year's sludge <br /> Quantity of sludge available this year <br /> Crop nitrogen requirements <br /> Resulting sludge loading rates for each field on the site are shown in Table 5. Sludge <br /> loading rates have varied from the plant nutrient application rates shown in Table 10 of <br /> the SMP for sugar beets and almonds. K&L Farms needs 125-150 lbs/acre of nitrogen to <br /> grow their desired yield of beets instead of the 60 listed in the SMP. K&L Farms also <br /> needs approximately 200-300 lbs/acre of nitrogen when the sludge is applied to their <br /> mature almonds. These values have been confirmed with the fertilization consultant used <br /> by K&L Farms. Actual loading rates are approximated here, and will be presented in the <br /> post-application report. <br /> Annual and cumulative loading of nutrients and metals are shown in Table 6. None of <br /> the cumulative or annual loadings are in excess of the criteria. <br /> Our agricultural consultant with CH2MHi11 produced our first pre-application report, <br /> dated Oct. 8, 1991. In this, he said that phosphorus is relatively immobile in the <br /> environment and large, single applications of phosphorus can be considered agronomic, <br /> and do not necessarily pose an environmental threat. <br /> He also said in the same report that zinc is deficient on the K&L soils, and an annual <br /> application rate of approximately 10 lbs per acre should be helpful. This reduces the <br /> requirement for supplementary zinc application and, in our case, zinc accumulation in the <br /> 2 <br /> Telephone 209/836-1650 3900 Holly Drive Tracy, California 95376 <br />