Laserfiche WebLink
SYSTEM WARNTNGS <br /> The ECAT Ondizer utilizes high temperatures, high voltages and flammable vapors <br /> to operate. All personnel operating the ECAT Oxidizer must be fully trained in the <br /> operation and maintenance of the system as well as the safety devices provided with <br /> the system. <br /> 1. Do not attempt to bypass any of the safety interlocks provided with the ox;dizer <br /> in an attempt to operate the oxidizer. <br /> 2. Do not modify or bypass the transformers, fuse blocks, or controllers in order to <br /> make the system operational. <br /> 3. Do not remove any equipment from the oxidizer in order to make the oxidizer <br /> operational. <br /> 4. beep all body parts clear of the exhaust stack, heat: exchanger piping, oxidizer <br /> chamber, air intake valves and moving parts due to burns from high <br /> temperature conditions and severe bodily injury situations that can occur as a <br /> result of body contact with these parts. <br /> 5. Do not restrict, block or close the exhaust stack during operation. <br /> 6. Disconnect incoming voltage to the oxidizer control panel before attempting to <br /> work on the panel or other electrical components on the oxidizer. Use a voltage <br /> meter to determine that the power is off. Have only qualified personnel work on <br /> the electrical components, preferably a qualified electrician. <br /> . 7 Do not operate the oxidizer above 11511° F Make sure that the High Limit <br /> Controller set point is set at 1 .51}©F or less before beginning operation. <br /> 8. Connect the systems auto dram discharge plumbing to an acceptable storage <br /> container prior to placing the liquid drain system In the "Auto" position. Unsafe <br /> liquid discharge can occur from improper use of the auto drain system. <br /> a <br />