Laserfiche WebLink
1k <br /> SYSTEM IYSTA LATIONAND START-UP <br /> 4 Follow each step fisted here in exactly the order Fisted. For your safety, do not slop <br /> any steps or performs any steps out of order. <br /> Installation- <br /> 1 Level the s3ad or trailer mounted system where you require installation on a dry <br /> surface. <br /> 2. Connect the properly rated electoral supply with a ground to the control panel main <br /> dtsconnect usmg a qualified electrician- <br /> 3 Check voltage, wire size and amperage rating of electricity installed, making sure <br /> that it matches the manufacturers panel spectficathons and electrical drawings before <br /> proceeding <br /> 4 Connect the process connection from the extraction wells We recommend an <br /> additional dilution valve be installed prior to the system entramnzent separator <br /> 5 Check 120-volt power circuit to see that all controllers and the chart recorder are <br /> powered up <br /> 6 Check rotation of the VES blower, liquid pump making stare they are correct <br /> Start-up Procedures- <br /> 1 Verify that the MAIN DISCONNECT switch on the control panel is m the "OFF" <br /> position <br /> 2. Turn the power"ON" at main power supply <br /> 3 Open the system control panel door and have a qualified electrician verify that the <br /> voltage at the top of the MAIN DISCONNECT is to manufacturer speciEcation. <br /> 4 With the control panel door closed and latched, turn the MAIN DISCONNECT <br /> switch to the "ON"position <br /> 5 Check that the EMERGENCY STOP switch is m the "OUT"position. <br /> 6 Turn the CONTROL POWER switch to the "ON" position. The controllers should <br /> come on along with the chart recorder <br /> 7 Push the BLOWER START button, the blower should come on and the LOW AIR <br /> FLOW ALARM light should go out. <br /> S. The SYSTEM OPERATIONAL light should come on, the oxidizer should begin <br /> heating up and the SYSTEM OFF light should go out <br /> 9 The TEMPERATURE CONTROLLER should come up to the 650°set point. <br /> 10 At 600° F the SYSTEM AT TEMPERATURE light should come on and the unit <br /> should slowly start to open the process isolation valve and close the dilution valve <br /> If any red alarn lights are on, the system will not become operational and will not <br /> come up to temperature. In the event of an Emergency, push the EMERGENCY <br /> STOP button <br /> Alarms are described below: i <br /> 1� <br />