Laserfiche WebLink
Replacing the ECPU Board Restoring System Setup Data - ECPU Board <br />Restoring System Setup Data - ECPU Board <br />1. Restore AC power to the console.The console front panel display will cycle through the following screens: <br />CLEARING ALL RAM <br />SYSTEM COLD START <br />SYSTEM SELF TEST <br />SYSTEM STARTUP COMPLETE <br />Wait until the printer prints: <br />*** SYSTEM RESET *** <br />MMM DD, YYYY HH:MM XM <br />and the front panel display reads: <br />MMM DD, YYYY HH:MM:SS XM <br />RESTORE SETUP DATA: NO <br />2. Push the Battery Backup switch (SW 1) up to the ON position. <br />3. Press the CHANGE key: <br />MMM DD, YYYY HH:MM:SS XM <br />RESTORE SETUP DATA: YES <br />4. Press the ENTER key: <br />RESTORE SETUP DATA: YES <br />PRESS <STEP> TO CONTINUE <br />5. Press the STEP key and the printer prints: <br />ARCHIVE UTILITY <br />RESTORE SETUP DATA <br />START TIME: <br />101M DD, YYYY HH: b24 XM <br />The console begins the restoring process of copying the system setup data you archived in the E2 chip into <br />the new ECPU board's RAM. Depending on how cornplicated your system setup data is, this procedure could <br />last for several minutes. When the restoring process is complete the printer prints out: <br />