Laserfiche WebLink
Replacing Software/Memory Modules on the ECPU Board <br />3. Follow the instructions in Figure 8 to install or replace these modules. <br />2 o ®®' <br />Attach one end of the \ i8J it <br />Archiving the System Setup <br />Removing modules - <br />Use your fingers to spread <br />retaining clips away from <br />the mdule board edges, <br />tilt theo board to the front <br />of the console and lift it out. <br />Module retaining clips <br />(one on each end) <br />)le OFF. <br />1 <br />Removing Software and Memory Modules <br />Seat module in connector J1 at <br />an angle with component side facing <br />i <br />y <br />the front of the console. Make <br />sure that notch in the bottom of <br />?i <br />the board is over ridge in base of�1I <br />connector, then push board back <br />1 <br />until retaining clips snap around the <br />`�++ <br />I= <br />board's edges. DON'T FORCE BOARD <br />or you may damage socket! Check <br />+k� <br />that notch and ridge are aligned <br />correctly then try again. <br />`+ -�, <br />1 ECPU bo d <br />ar <br />Retaining clip (2)- `, / <br />y - <br />i <br />Front of console J --j <br />�—_ 'p — J'I J2 / <br />View A -A (above) <br />Installing Software and Memory Modules <br />conso:evsctt-cerrbd in.eos <br />Figure 8. Removing and Installing a Software or Memory Module <br />4. Perform a cold boot as described in "Restoring System Setup Data - ECPU Board" on page 11. <br />14 -- �— <br />