Laserfiche WebLink
Apply a bead of Blue Bond 801 around the housing threads <br />and thread the repair boot onto the housing. <br />STEP 8 <br />STEP 9 <br />STEP 10 <br />STEP 11 <br />STEP 12 <br />Index the repair boot with the fill tube at the 12:00 position. <br />Install the split insert around the pipe and apply a liberal <br />bead of Blue Seal Glue along the seam and lightly hold or <br />clamp until cured. <br />Install the insert into the repair boot. <br />Install the rear clamp and tighten to 65 inch lbs. (Be careful <br />not to do this until the Blue Bond 801 is cured.) Install the <br />outer clamp loosely so that air can escape between the insert <br />and the boot while the boot is being filled with Bostik sealant. <br />Fill the entire boot cavity with Bostik 1I00FS sealant. As the <br />boot fills it will begin to pressurize and push the insert <br />outward. <br />Tighten the outer clamp to 65 inch lbs. Clean up any excess <br />sealant and allow 24-48 hours for Bostik 110OFS sealant to <br />fully cure. <br />