Laserfiche WebLink
2 Installation Installing TLS Console Modules - General Notes <br />I <br />16 .'__8' <br />W-5: <br />7 <br />1 2 3 4 <br />14_1 <br />__- <br />13..: <br />6 <br />Intrinsically <br />5 Safe Bay <br />12 <br />..4 Permissible =i <br />Modules <br />Comm Cage' <br />�b�r,ts s; <br />per console) <br />,. - <br />.: -----------------=: <br />Figure z -z. lis console Interface Module Bays <br />ACAUTION! During programming, module positions and the devices wired to each module are identified and stored <br />in memory. If a connector is removed and reinstalled on a different module after programming, or if an entire <br />module with its connector is removed and reinstalled in a different module slot, the system will not properly <br />recognize the data being received. <br />Module Position <br />1. Record on the circuit directory the type of module in each slot location. <br />2. If a system contains multiple modules of a single type (i.e., two Smart Sensor Modules), they may be swapped <br />between their respective slot locations, however, the connectors must remain with their original locations, <br />not with the original modules. <br />Connector Position <br />1. Identify all connectors according to their slot location using the self-adhesive numbering labels furnished with <br />each module. Accurately record on the circuit directory the location of each device wired to the connector as <br />you attach wires to the module. <br />2. Once a device has been wired to certain terminals on a connector and the system has been programmed, the <br />wires from that device may not be relocated to other terminals without reprogramming the system. <br />Grounding Probe and Sensor Shields <br />Connect probe and sensor cable shields to ground at the console only. Do not ground both ends of the shield. <br />CIRCUIT DIRECTORY <br />A circuit directory is adhered to the inside of the right-hand door. It should be filled out by the installer as the <br />module's connectors are being wired. <br />The following information should be recorded for each slot: <br />• Module Type: record what type of module has been installed in the slot, e.g., Smart Sensor Module. <br />• Position Record: record the physical location and/or type of device wired to each terminal of the module <br />connector in the slot, e.g., AFM1. <br />2-2 <br />