Laserfiche WebLink
0 - Multi-Sync Installation Instructions <br /> DPM MIM0111 For Blueline Medium Fittings <br /> Oa This kit provides the Multi-Sync Repair for applications where the pipe is coming thru the <br /> 1a•••1�` sump wall straight or at an angle. <br /> WARNING:Prepare all surfaces to be bonded prior to completing installation steps below. <br /> Failure to follow each step will void warranty&may result in premature failure of penetration fitting. <br /> MSZ BLM-xx <br /> Page 1 This Kit applies for repairing:Blueline Medium Fittings <br /> General Instructions for: CLEANING:Spray all surfaces to be bonded with DEC Cleaner and allow to air dry or wipe excess with a clean dry <br /> cloth. Surfaces must be dry before applying bonder. <br /> General Instructions for: BONDING TO POLY SUMPS OR FIBERGLASS SUMPS: Clean,sand and rough up sump surfaces. Clean fitting and <br /> apply DBB V between Bonding Ring&sump wall. On Poly Sumps if sump wall is un-even use DRP in place of DBB V. <br /> STEP 1: Remove Old Boot STEP 2: Clean all Repair Components STEP 3: Place&Dry Fit Cuff Ring,Sleeve&Insert <br /> • Remove clamps Clean all repair components with DBC Wrack the split cuff ring over the old fitting <br /> • Cut away old boot prior to installation Wrack the split insert over the pipe <br /> • Clean&sand fitting Wrack the split sleeve over the pipe&up to the <br /> Split Cleaner Split bonding ring with the fill port up <br /> Cuff <br /> Sleeve <br /> Ring r <br /> uar <br /> tta <br /> Eccentric Insert Split Multi-Sync <br /> Insert Reducer <br /> 5.:. <br /> If everything fits continue with STEP 5: Install The Sleeve,Cuff Ring&Insert STEP 6:Install&Bond Eccentric Insert&Multi-Sync <br /> the install. If there is a problem Apply DBB V to the outer surface of the insert Reducer Back Together <br /> and fully seat inside of cuff Wrack Eccentric Insert around the pipe <br /> with the fit&function of these Apply DBB V to the inner surface of the cuff Wrack Multi-Sync Reducer around the pipe <br /> parts,either adjust to make fit if ring and slide all the way onto the cuff Apply Zip Tite to split area on Eccentric Insert,press <br /> possible,or call the factory(530- Position the sleeve with the fill port at the top ends together&clamp <br /> 534-3966) for additional help Once you have the sleeve lined up correctly, Apply Zip Tite to split area on Multi-Sync Reducer, <br /> 1.Apply a bead of Zip tite all around the press ends together&clamp <br /> STEP 4: Bond Sleeve,Cuff Ring&Insert outer surface of the cuff ring <br /> • Apply Zip Tite to split cuff ring. Use 1 of 2.Slide sleeve over cuff ring&snap in place <br /> the clamps to hold in place while curing. (fill port at top) <br /> • Apply Zip-rite to the split insert and use 1 3. Set the Clamp the around the sleeve& <br /> of the clamps to hold in place while over the cuff ring and tighten"snugly". <br /> curing. <br /> • Apply Zip Tite to the split sleeve and use 2 <br /> clamps to hold in place while curing. > j <br /> • Leave these clamps in place for approx 30 <br /> minutes for curing before proceeding to <br /> the next step t <br /> e ` imam <br /> N <br />