Laserfiche WebLink
CONTACT US FOR MORE INFORMATION! <br />�`��' 1555 Copperhill Parkway, Santa Rosa, CA 95403 <br />Q,rB$$ Ph: 707.523.2050 <br />3/8" Stainless Steel Test Port for DW FRP Sumps <br />INSTALLATION INSTRUCTIONS <br />Materials Required: <br />Resin and Catalyst, Part # AC 1040 <br />Fiberglass Mat, Part # AC8025 <br />Y . . <br />Acetone, Part # AC 1070 <br />Grinding wheel 24 grit P Pori Test Port <br />Shop towels or clean rags <br />Western Fiberglass Stainless Steel Port Fitting, Part # P10012 <br />Bonder, Part # DWAC4500 Test valve <br />Purpose: <br />This procedure is specifically for the installation of stainless steel fittings in Western <br />Fiberglass Sumps. This procedure is to be performed by Western Fiberglass trained and <br />certified personnel only. Only materials identified in this procedure may be used for this <br />procedure. This procedure may be used on other manufacturer's sumps provided the <br />materials of the sump have been identified and have been determined to be <br />compatible with the materials used for this procedure. <br />INSTALLATION PROCEDURE <br />Installing the Fitting: <br />• Mark the placement of the fittings on the sump wall. <br />• Using a 5/16" drill, drill the spot marked for the port. Use extreme caution to only <br />drill through the inside wall of the double wall sump. DO NOT BREACH THE OUTER <br />WALL. <br />• Prepare the surfaces to be glassed on the inside of the sump wall by grinding <br />the walls to remove all foreign material and to develop a surface for the <br />fiberglass and bonder to adhere. Clean the entire surface prepared with <br />acetone. <br />• Place a'/4" bead of bonder around the back side of the fitting plate, 1/4" inside <br />the outer edge. <br />• Press the fitting onto the inside of the sump wall as marked. Use an ink pen, nail <br />or a screw to line up the hole in the sump wall with the hole in the port. Wipe off <br />any excess bonder to make a smooth seal. This is to provide a smooth surface <br />for applying the glass. <br />• Glass the stainless steel plate to the wall of the sump using catalyzed resin. Make <br />sure to roll out the glass for a proper bond and to remove air bubbles. <br />• Give the glass adequate time to begin to cure before testing or adding liquid to <br />the sump. The glass must not be able to be dented by a fingernail pressed into <br />it. <br />E C' E <br />E D <br />Ph: 707.523.2050, Fx 707.523.2046 � IV Page 1 of 2 <br />sales@westernfg.com, www.westernfg.com MAY S 1 2018 <br />ENVi 10NNi1E! !AI_ <br />