ARCHIVED REPORTS XR0006486 - Laserfiche WebLink

Home Browse Search

REG 603 UPDATE-7 3/24/92 • C. VAPOR: C. 1. VAPOR RECOVERY SYSTEM AND MONITORING As stated in Update Status Report #5, monitoring wells MW1, 14W2, MW3 , MW10 and the excavation 6 inch (EX-411 ) have been manifolded to a vapor extraction system with individualed valved orifices for flow control sampling and vacuum and flow measurements from the individual wells. MW2 and MW3 are manifolded together with 2" tubing T' ed at the wells, but can be individually tested by placing a packer below the extraction T of the well to seal that well from the vacuum system, see Figure 7. The individual wells are fitted with a PVC "T" heads with a air tight cap, for well access. The "T" lateral (211 ) is fitted with a 1/4" pipe to tubing fitting for obtaining vacuum/pressure and temperature readings. Wells MW2, and EX-4" are fitted with a pipe to hose 2" fitting placed between the "T" and the 2" PVC flex hose that goes from the well to their individual condensate drop outs that hook into the extraction manifold. The 3" SCH 40 PVC lateral from MW3 is also fitted with a 2" pipe to hose fitting where it enters the traffic box near MW2 and is T ' ed to the 2" tubing from MW2 at that point. • MW1 is fitted with a 2" PVC Y to allow access to the well off the straight leg of the Y and vapor recovery off of the angled leg of the Y. The vacuum recovery piping from this point rises 7 feet into the air prior to an 90 degree elbow connecting 2" PVC pipe at a slight incline towards the eastern fence of the compound, 8 feet above the surface. At this point the PVC pipe drops into the condensate drop out tank for MW1, prior to the vacuum extraction manifold. MW10 is manifolded to the treatment compound via SCH 40 PVC pipe underground west towards the store. Once the pipe reaches the store it connects into a condensate drop out tank (Approximately 5 gallon capacity) prior to heading over the roof of the store with 2" galvanized pipe. The condensate tank is below ground in a concrete lined traffic box. The condensate collected in this tank is removed weekly via an air tight valve attached to the top of the air tight lid of the tank. Once the pipe reaches the roof of the store, it 90 degree elbows into SCH 40 UV protected PVC pipe and heads across the roof towards the treatment compound where it 90 degree elbows down the wall into a second condensate drop out tank prior to tae mana.foid. At the manifold the individual wells condensate tanks are connected to their own 2" PVC riser ( 36" in height) with an orifice plate and a gate valve at the top of the riser. Vacuum/pressure ports are located on either side of the orifice plate. Each orifice (well) has its own monometer (calibrated in millimeters (mm) oil) which are hooked to the ports for continuous measurement of flow from a particular well or in the case of MW2 and MW3 combination of wells. All the extraction wells are manifolded together above the gate valve to a 4 inch orifice riser prior a filter in front of PAGE 7