SU0002976 - Laserfiche WebLink

Home Browse Search

above the adjacent screen. Screening is not required between industrial properties. (Development Title Section 9-1022.4[e][21[A]) i. ACCESS AND CIRCULATION: The following requirements apply and shall be shown on the Site Plan: (1) The driveway width at the ultimate right-of-way shall be a maximum of 40 feet. The design of the driveway shall allow trucks to enter and exit the property without entering into the opposing lane of traffic. (Development Title Section 9- 505.7) (2) Access gates shall be open for business hours or recessed from the property line a minimum of 65 feet. (Development Title Section 9-505.7) (3) Adequate maneuvering and parking areas of automobiles and trucks shall be located on the site of the truck terminal. (Development Title Section 9-505.7) (4) Aisles between truck parking areas shall be a minimum of 55 feet wide. (Development Title Section 9-1015.6[d][21) (5) The entrance to the facility shall be located on the project site, or a mutual easement for ingress and egress shall be recorded prior to a final certificate of occupancy. j. SIGNS: All portions of any sign shall be set back a minimum of five feet from any future right-of-way line, including any corner cut-off (snipe). (Development Title Section 9- 1717.2[g]) k. NOISE LEVELS: The following noise regulations apply to this project: (1) Noise levels of trucks entering and leaving the truck terminal shall comply with the California Vehicle Code sections regarding noise. (Development Title Section 9-505.6[b]) (2) Noise levels at the property lines of Assessor Parcel Numbers 179-080-09, 10, and 11 shall be no greater than 65 db Ldn. (Development Title Section 9- 1025.9[a][i] or 505.6[c]) (3) This project shall comply with the performance standards specified in Table 9- 1025.9 of the Development Title. I. BUILDING CODE REQUIREMENTS: The following Uniform Building Code and San Joaquin County Ordinance requirement will be applicable and shall be incorporated in the construction plans before submittal to the Building Inspection Division: (1) If welding or major truck repairs are contemplated, the building will be classified as an H-4 occupancy, and fire sprinklers will be required where the floor area is greater than 3,000 square feet. Revised Conditions - 3 - SA-96-20