Laserfiche WebLink
3 - <br /> Single Zone Completion Procedure <br /> 1. Pick-up 2-3/8" tubing with ..i" collars and G.O. 41" casing to 101+ below any <br /> future proposed performations . Run CBL and gamma-collar correlation log. <br /> Close rams and pressure test 42" casing to 2500 PSI after running CBL log. <br /> Perforate 4?" holes above all proposed zones and test for W.S.O. as required <br /> for D.O.G. Circulate out the drilling mud with water. Rerun and land open-ended <br /> tubing with pump shoe f50' above all major proposed performation intervals, <br /> within reason. After installing tubing bonnet, repressure test casing and tubing <br /> head to 2 ,500 PSI. <br /> 2. Displace water I.H. with nitrogen, depressing the F.L. 1500' downhole. Rig <br /> up 3,000 W.P. grease injector lubricator and perforate the proposed intervals <br /> through tubing and underbalanced, using 1-3/4" Magnum Swing jet. <br /> 3. Flow test and evaluate well. Release rig. <br /> Dual Zone Completion Procedure <br /> 1. Pick-up 2-3/8" tubing with 3"" collars, bit and scraper and C.O. 5 2" casing to <br /> 104- below any future proposed perforations . Run CBL, gamma-collar correlation <br /> log. Close rams and pressure test 52" casing to 2500 PSI after running CBL log. <br /> Perforate 4-111 holes above all proposed zones and test using dry tester as required <br /> for D.O.G. Perforate 4-1" holes above the lower most zone and W.S.O. Circulate <br /> the drilling mud O.H. with f75 PCF clean salt water containing 3% by weight of <br /> KCL. Across the interval to be perforated, spot a pill containing 1 PPB of X-C <br /> polymer. <br /> 2. Set a Baker Model "FB-1 packer" with 3 .000" bore with 10' tail with 1.81' <br /> seating nipple below the packer. <br /> 3. Perforate the upper interval with 42" H/F using 4" O.D. casing gun. <br /> 4. Hydrotest 2-3/8" tubing I.H. with seal assembly and model "L" sliding sleeve <br /> *10' above seal assembly. Model "L" to contain 1 .87' seating nipple. Blast <br /> joints to be installed 10' above and below perforated interval. <br /> 5. Land tubing in packer and pressure test seal assembly and tubing to 2500 PSI. <br /> Install Christmas tree and retest tubing, tree and seal assembly when installed. <br /> Test to 2500 PSI between donut and bonnet to test tubing spooltree connection. <br /> 6. Open sliding sleeve and circulate completion fluid out of the tubing and casing <br /> j with nitrogen to bring on the annulus zone. Continuously inject nitrogen until <br /> no solids content is observed to prevent a solids bridge from occurring in the <br /> 4 annulus . <br />