Laserfiche WebLink
7.1 and 7.2 above need not be provided when design <br /> stresses have been adjusted as specified in Chapter <br /> 21 to permit noncontinuous inspection. <br /> ( ) 8. REINFORCED GYPSUM CONCRETE. When cast-in-place Class B <br /> gypsum concrete is being mixed and placed. <br /> ( ) 9. INSULATING CONCRETE FILL. During the application of <br /> insulating concrete fill when used as part of a <br /> structural system. <br /> EXCEPTION: The special inspections may be limited to an <br /> initial inspection to check the deck surface and <br /> placement of reinforcing. The special inspector shall <br /> supervise the preparation of compression test specimens <br /> during this initial inspection. <br /> ( } 10. SPRAY APPLIED FIREPROOFING. As required by U.B.C. <br /> Standard 7-6. <br /> ( ) 11. PILING, DRILLED PIERS AND CAISSONS. During driving and <br /> testing of piles and construction of cast-in-place <br /> drilled piles or caissons. See Items 1 and 4 for <br /> concrete and reinforcing steel inspection. <br /> { ) 12 . SHOTCRETE. During the taking of test specimens and <br /> placing of all shotcrete and as required by Section <br /> 1922.10 and 1922. 11 . <br /> EXCEPTION: Shotcrete work fully supported on earth, <br /> minor repairs and when, in the opinion of the building <br /> official, no special hazard exists. <br /> 13. SPECIAL GRADING, EXCAVATION AND FILLING. During earth- <br /> work excavations, grading and filling operations <br /> inspection to satisfy requirements of Chapter 18 and <br /> Appendix Chapter 33 of this code. <br /> ( ) 14. SMOKE-CONTROL SYSTEM. <br /> 14.1 During erection of ductwork and prior to <br /> concealment for the purposes of leakage testing and <br /> recording of device location. <br /> 14.2 Prior to occupancy and after sufficient completion <br /> for the purposes of pressure difference testing, <br /> flow measurements, and detection and control <br /> verification. <br /> SIA.DOC <br /> 4 - <br />