Laserfiche WebLink
Step 2 - Installing the Black Spill Container onto the M/F 4X4 Riser Adaptor <br /> A. By hand, thread the black spill container onto the male threads of the M/F 4X4 riser adapter <br /> taking care not to cross thread the spill container riser. These threads are straight threads not <br /> NPT pipe threads. The spill container must screw down and seat on the top of the drop tube <br /> flare (Fill) or on the top of the M/F 4X4 riser adaptor sealing surface (Vapor). <br /> Step 3 —Tightening the Spill Container <br /> Using a '/z" drive torque wrench and the Black tool adapter (T-7101 or T-7002, Black) from <br /> Phil-Tite T-7043 Tool Kit, tighten the Spill Container onto the M/F 4X4 Riser Adaptor threads to <br /> a torque value between 75 and 100 ft. Ibs. <br /> Step 4 — Final Installation <br /> Check the measurement from the top of the black spill container to the top of the stainless <br /> steel sleeve at finish grade. Ensure there is at least 1 1/4" inches of clearance (more is OK) <br /> from the top of the black spill container to the top of the stainless steel sleeve at finish grade. <br /> This will allow for the water tight cast iron lid to fit properly and ensure that the spill container <br /> and tank riser are not in direct contact with the cast iron lid. This ensures the concrete with <br /> manway cover are not load bearing onto the tank fill and vapor risers. <br /> Step 5 — Drain Valve Testing <br /> Test the drain valve assembly as described in CARB procedure TP-201.1 D. <br /> Step 6 —After Spill Container Installation <br /> The spill container is now ready for the installation of the rotatable (swivel) adaptor and dust <br /> cap. Install the fill and/or vapor swivel adaptor using the SWF-1008/SWV-101 B Installation <br /> Instructions. <br /> 4of8 <br />