COMPLIANCE INFO_2017 - 2018 - Laserfiche WebLink

Home Browse Search

Step 2 -.Dry fit your riser to verify your measurements. A. After you have dry fitted all components and are satisfied with your measurements, apply an approved fuel resistant, non hardening thread sealant (pipe dope) to the NPT threads on both ends of the tank risers. Step 3 - Install the correct length tank risers A. Install and torque the 4" tank risers into the tank bungs. 85000-1 Series Spill Container Installation Step 1 — Preparing the Black Spill Container for Installation A. Inspect the black spill containers ensuring that the 1/4" flat seal is in place and properly oriented for sealing onto the flared top of the drop tube (Fill) or on the M/F 4X4 Riser Adaptor (vapor). On Fill spill containers ensure the drop tube has the special Phil-Tite "O" Ring (85039-DT) installed under the upper drop tube flare and is seated on top of and inside the M/F 4X4 riser adaptor installed on top of the tank riser. If you are using a straight drop tube from a different manufacturer, discard the "O" Ring that may have been shipped with this drop tube and use the special Phil-Tite "O" Ring (85039-DT) that is shipped with each Fill Spill Containers. B. 85000-1 Fill Only. Inspect the foam filter located inside the container. The filter should be lying flat and secured by the stainless steel snap ring. Move the drain valve handle back and forth making sure that the lower screen assembly rises (compresses) when moved to the open position and extends when closed. The drain valve handle should move freely with no binding and must snap into place when moved to the closed position. C. ALL SPILL CONTAINERS - NOTE: DO NOT USE ANY TYPE OF THREAD SEALING COMPOUND (PIPE DOPE) FOR SPILL CONTAINERS INSTALLATION! Apply an even coat of Anti-seize compound to the black spill container female threads and/or to the M/F 4X4 riser adaptor male threads or apply a light Silicon based spray. This will reduce the friction between these threads during installation and aid in removal of the spill containers at a later date. Phil-Tite Spill Containers create an optimum, leak free seal when properly tightened (torque) to the M/F 4X4 riser adaptor. When installing the black spill containers in a direct bury application apply an even coat of Silicon based spray to the large outer "0" Ring seal of the black spill container and to the inside of the stainless steel sleeve to ease insertion. Note: For multi-port installations - Apply an even coat of Silicon based spray to the large outer "O" Ring seal of the black spill containers(s) and to the inside of the stainless steel sleeve(s)just prior to installing the manway cover with stainless steel sleeves. This will aid in installing the manway cover over the installed spill containers. 3 of 8