Laserfiche WebLink
k'■ KLEINFELDER <br /> • A 3- to 5-foot bentonite plug is placed above the sand pack to provide a seal against <br /> surface water infiltration and to reduce the potential for cement grout to infiltrate into the <br /> water. <br /> • The remaining annular space is filled to the surface with cement bentonite grout. <br /> • The wells are secured in an aboveground or underground locking stovepipe. The well heads <br /> may be enclosed in a water tight cement utility box set flush to the ground surface when <br /> located in a traffic area. <br /> B-3.2 Monitoring Well Development <br /> The wells are developed to reduce the effects of drilling on the formation and to increase the <br /> effective hydraulic radius of the wells. <br /> Monitoring wells are generally developed 24 to 48 hours after installation to allow the grout to <br /> set. Each well is first sampled with a clear disposable bailer to visually inspect for a <br /> hydrocarbon layer or sheen. if no product layer or sheen is observed on the water, the well is <br /> developed by surging, pumping or bailing. Surging along the screened interval of the well is <br /> performed to draw the sediment from the formation into the filter pack and the well, and to set <br /> the sand pack. Development continues until the discharge runs relatively clear of fines. <br /> Approximately 5 to 10 well volumes are generally removed from each monitoring well. <br /> Discharge water is stored in 55-gallon drums and left on site for later discharge or disposal by <br /> the client, depending on laboratory results. The drums are labeled with the date, well number, <br /> and a contact person and phone number. <br /> 20-YP9-022/2019P156 Page 6-5 <br /> Copyright 1999 Kleinfekler. Inc. May 18, 1999 <br /> sJ <br />