Laserfiche WebLink
i <br /> Project No.034-98081 <br /> Page No. 12 <br /> 5.3 Packaging and Shipment of Samples <br />' t Eye Protection: Impact resistant safety glasses with attached side shield wi <br /> • ll be <br /> worn while packaging samples for shipment. <br /> • Hand Protection: Butyl rubber or nitrile gloves Will be worn under disposal PVC <br /> gloves. <br /> All samples will be shipped strictly to a state approved laboratory. Shipping must comply with <br /> Department of Transportation (DOT)regulations. The following instructions will be followed to comply r <br /> with DOT regulations: <br /> • Tape all lids with electrical or other tape, <br /> Wrap the primary container with absorbent brown paper(wading), � <br /> •••��� Place the primary container in a plastic bags (zip flock, or equivalent) <br /> • Place into an ice chest with a synthetic or double-'bagged water ice <br /> s <br /> • Tape or secure the ice chest lid and secure with a chain of custody seal (if <br /> k applicable) <br /> • Labels identifying the generator's name, address and.known content of the drum <br /> In the event that samples are to be personally transported to the state-approved laboratory, some of <br /> the above packaging and shipping requirements may not apply. Any questions should be referred to the <br /> i <br /> project manager. I <br /> E , <br /> - t <br /> 5.4 Sample Preparation and Analysis of Samples <br /> All laboratory safety practices should be accomplished in accordance with the specific labs policy. <br /> Krazan &Associates, its owners, clients, employees, and--represeptatives are not responsible for safety on <br /> f <br /> laboratory premises. Therefore,both shall be held harmless in the event of any mishap,accident or long term <br /> adverse health effects occurring or originating at the subcontractor laboratory. <br /> - k <br /> � k <br /> r <br /> KRAZAN& ASSOCIATES,:TNC. <br /> Offices Serving the Western United States <br />