COMPLIANCE INFO_PRE 2019 - Laserfiche WebLink

Home Browse Search

Product name: KATHONTm FP 1.5 BIOCIDE Revision Date:22.03.2015 Version:4.0 6.3 Methods and materials for containment and cleaning up:WARNING: KEEP SPILLS AND CLEAN-UP RESIDUALS OUTOF MUNICIPAL SEWERS AND OPEN BODIES OF WATER.Adsorb the spill with spill pillows or inert solids such as clay or vermiculite,and transfer contaminated materials to suitable containers for disposal. Deactivate spill area with freshly prepared solution of 5% sodium bicarbonate and 5%sodium hypochlorite in water. Apply solution to the spill area at a ratio of 10 volumes deactivation solution per estimated volume of residual spill to deac tivate any residual active ingredient. Let stand for 30 minutes. Flush the spill area with copious amounts of water to chemical sewer(if in accordance with local procedures,permits and regulations).DO NOT add deactivation solution to the waste pail to deactivate the adsorbed material.See Section 13,"Disposal Considerations',for information regarding the disposal of contained materials. 6.4 Reference to other sections: References to other sections,if applicable, have been provided in the previous sub-sections. SECTION 7. HANDLING AND STORAGE 7.1 Precautions for safe handling:This material is a severe irritant. For personal protection see section 8. Do not handle material near food,feed or drinking water. 7.2 Conditions for safe storage,including any incompatibilities: Keep in a well-ventilated place. The product as supplied may evolve gas(largely carbon dioxide)slowly.To prevent the buildup of pressure the product is packaged in specially vented containers,where necessary. Keep this product in the original container when not in use.Container must be stored and transported in an upright position to prevent spilling the contents through the vent,where fitted. Do not store this material in containers made of the following: steel Do not store this material near food,feed or drinking water. CONTAINERS MAY BE HAZARDOUS WHEN EMPTY. Since emptied containers retain product residue follow all MSDS and label warnings even after container is emptied. Expiration date based only on retention of>95%actives during storage at 20°C-250C(680E-770F). Storage stability Storage temperature: 1 -55°C 7.3 Specific end use(s):See the technical data sheet on this product for further information. SECTION 8. EXPOSURE CONTROLS/PERSONAL PROTECTION 8.1 Control parameters Exposure limits are listed below,if they exist. 8.2 Exposure controls Engineering controls:Use local exhaust ventilation with a minimum capture velocity of 150 ft/min. (0.75 m/sec.)at the point of dust or mist evolution. Refer to the current edition of"Industrial Ventilation:A Manual of Recommended Practice"published by the American Conference of Governmental Industrial Hygienists for information on the design, installation,use,and maintenance of exhaust systems. Protective measures: Facilities storing or utilizing this material should be equipped with an eyewash facility and a safety shower. Individual protection measures Page 5 of 15