Laserfiche WebLink
Product name:KATHONTm FP 1.5 BIOCIDE Revision Date:22.03.2015 <br /> Version:4.0 <br /> Eye/face protection:Use chemical splash goggles and face shield(ANSI Z87.1 or approved <br /> equivalent). Eye protection worn must be compatible with respiratory protection system <br /> employed. <br /> Skin protection <br /> Hand protection:Chemical-resistant gloves should be worn whenever this material is <br /> handled. The glove(s)listed below may provide protection against permeation. <br /> (Gloves of other chemically resistant materials may not provide adequate protection): <br /> Butyl-rubber. <br /> Nitrile rubber. <br /> Gloves should be removed and replaced immediately if there is any indication of <br /> degradation or chemical breakthrough.Rinse and remove gloves immediately after <br /> use. Wash hands with soap and water.NOTE:Material is a possible skin sensitizer. <br /> Other protection:Wear as appropriate: <br /> Chemical resistant apron <br /> Complete suit protecting against chemicals <br /> Respiratory protection:Typical use of this material does not result in workplace exposures <br /> that exceed the exposure limits listed in the Exposure Limit Information Section.For those <br /> special workplace conditions where the listed exposure limits are exceeded,a respiratory <br /> protection program meeting OSHA 1910.134 and ANSI Z88.2 requirements must be followed. <br /> For concentrations up to 10 times the exposure limit,wear a properly fitted NIOSH approved <br /> (or equivalent)half-mask or full facepiece air purifying respirator equipped with organic vapor <br /> cartridges and N95 filters.If oil mist is present,use R95 or P95 filters. For those unlikely <br /> situations where exposure may greatly exceed the listed exposure limits(i.e.greater than 10- <br /> fold),or in any emergency situation,wear a properly fitted NIOSH approved(or equivalent) <br /> self-contained breathing apparatus in the pressure demand mode or a full facepiece airline <br /> respirator in the pressure demand mode with emergency escape provision. See SECTION 6, <br /> Accidental Release Measures,for respirator and protective clothing requirements for spill <br /> clean-up and decontamination of this material. <br /> Environmental exposure controls <br /> See SECTION 7:Handling and storage and SECTION 13: Disposal considerations for measures to <br /> prevent excessive environmental exposure during use and waste disposal. <br /> SECTION 9. PHYSICAL AND CHEMICAL PROPERTIES <br /> 9.1 Information on basic physical and chemical properties <br /> Appearance <br /> Physical state liquid <br /> Color colorless to pale yellow clear <br /> Odor aromatic <br /> Odor Threshold no data available <br /> PH 4.4 <br /> Melting point/range no data available <br /> Freezing point <-20°C <br /> Boiling point(760 mmHg) 229.00°C Solvent <br /> Flash point 138.00°C PENSKY MARTENS CLOSED CUP <br /> Evaporation Rate(Butyl Acetate <1.00 Water <br /> =1) <br /> Page 6 of 15 <br />