ARCHIVED REPORTS_XR0012597 - Laserfiche WebLink

Home Browse Search

E. t FF.L-O1-Ql�E}0 Of9:?.J FF'iill Til ?-1- stored on ice. The sample sealing technique consiRstod of capping the brass tube with aluminum foil., plastic end cap F; and a final seal of elastic tape. The previously sealed sample from the five foot depth at location MCW �1 was discarded. Following the collection of sample MCW 11, the auger and tube driver were thoroughly decontaminated utilizing a potable water/laboratory reagent soap mixture wash followed by a potable water rinse and a deionized water final rinso. rhe next location sampled was MCW 02. This location is between the central tank and the so,.ithern most tank (T2 and T3) . An with location MCW 11, sampled were collected at depths of five feet and nine feet PGS. The five foot depth sample from MCW #2 was labeled MCW 02-5 and the nine foot depth sample was labeled MCW 02. Doth of these samples were field screened, sealed, labeled and stored on ice. Attempts were made to sample several other locations in the vicinity of the three tanks, but to no avail. Auger rejection occurred at depths of two to three feet BGS at three alternative locations near the tanks. Therefore, the derision was made to }seep the five foot depth sample from location MCW X92 for analysis. Next, the area around t:hF fuel distribution pipelinrsl, was sampled. Two locations (PL 91 and PL 12 as shown on Figure 1) were selected. Location PL 01 was sampled first. Again, prior to sampling, the auger was thoroughly decontaminated as explained previously. r Borehole PL 11 was advanced to a depth of eight feet BGS with the hand auger. sample PL #1 was collected at this depth, field screened, sealed, labeled and stored on ice. Borehole Pi 12 was advanced to a depth of five feet, at which depth the auger could not be advanced further. Sample PL #2 was collected from this depth. Finally, a sample was collected from the fuel dispenser island area. open dirt existed beneath a coverplate near an overhead structure support pole. This coverplate was installed to allow for access to the lighting electrical conduit which rises from below gr4?a at that point. The borehole at this location could only be advanced 1.3 feet BGS. sample FL was collected from that depth. once completed, the samples were stored in a refrigerated environment over night for delivery to the analytical laboratory the following morning. Appropriate chain of custody documents accompanied the sample delivery. The sample chain of castody record is enclosed with the analytical results In Appendix A. .All PID-readings-forthe field screened nampins are listed in Table 1. 3