Laserfiche WebLink
Mike Infurna [EH] <br /> From: John A Izbicki Daizbick@usgs.gov] <br /> Sent: Friday, July 08, 2005 8:18 AM <br /> To: Mike Infurna [EH]; John A Izbicki <br /> Subject: Fw: Phone call from Mike Infurna- San Joaquin County Environmental Health Inspector <br /> Hi Mike-- <br /> Thanks for speaking with Dennis and Rhett, and thanks very much for being <br /> helpful. I appreciate the effort. Although most of the issues have been <br /> apparently cleared-up in your phone conversations this e-mail may help <br /> address the issues you and Rhett discussed. <br /> First--the HDP wires are 1/8 inch diameter, and ther are two tubes for the <br /> suction-cup lysimeters each tube is 1/8 inch diameter. <br /> Second--The address is correct. The City is operating the site as a <br /> ground-water recharge facility (hence the need for the work) . <br /> Third--We can modify the seal to address your concerns. However we a <br /> careful with hydrated grout because we are monitoring in the unsaturated <br /> zone, water added during drilling alters our results. I can emplace the <br /> grout partly hydrated if that would make you more comfortable. I also can <br /> use a different grout mixture and eliminate the #3 sand infil. The sand <br /> provides structural support for the grout in very deep boreholes (as much <br /> as 600 ft to water) . The depth to water and the depth of the upper grout <br /> seal at the proposed site is less than 60 ft and I am not concerned about <br /> the weight of the grout shifting the backfill and instruments in the <br /> unsaturated zone. <br /> Fourth--We did not note a perched water table while drilling the previous <br /> hole. The instruments are intended to evaluate the development of a perched <br /> water table during artificial recharge. <br /> Fifth--Any thing you can do to help us start on time would be greatly <br /> appreciated. Dennis said that you could have someone fill-in for you for <br /> the inspection. <br /> Let me know what you think (either by e-mail or phone (858) 637-6831) . I <br /> can stop by to discuss the site with you and make any needed modifications <br /> to our design or the permit before we start drilling. Dennis Clark is <br /> FAXing you the revised permit showing the US Geological Survey as the <br /> responsible party for the extra billing. <br /> Thanks <br /> John Izbicki <br /> (858) 637-6831 <br /> ----- Forwarded by John A Izbicki/WRD/USGS/DOI on 07/08/2005 07:59 AM ----- <br /> --------------------------------------> <br /> -------------+----------------------------> <br /> I I Rhett R Everett I <br /> I I I <br /> I 07/07/2005 04:58 I <br /> I PM I <br /> ---------+----------------------------> <br /> >----------------------------------------------------------------------------------------- <br /> ----------------------------------------I <br /> I <br /> I <br /> To: John A Izbicki/WRD/USGS/DOI@USGS <br /> I <br /> 1 <br />