Laserfiche WebLink
AEROSOL <br /> 00 REROSOLVo CAN RECYCLING <br /> o <br /> SAFETY INSTRUCTIONS <br /> 1.Wear safety goggles while operating Aerosolv. <br /> 2.DO NOT use Aerosolv while smoking or near open flame. <br /> 3.Install Anti-Static Wire to properly"ground"drum. <br /> 4.Combination Filter MUST be installed prior to using Aerosolv,Replace Carbon <br /> Cartridge as indicated. <br /> 5.DO NOT use Aerosolv on a drum with less than 20-gallon capacity. <br /> 6.Remove Aerosolv to an empty drum once collection drum is 70%full(when contents <br /> reach within 10"of the top). <br /> 7.Always engage sliding top plate against can being punctured. <br /> 8.Always operate AEROSOLV system outdoors or in a well-ventilated area. <br /> 9.Tip:Avoid puncturing aerosol cans of cold galvanizing compound or insulation foam, <br /> unless can is empty. <br /> '*A R E R O S O M INSTALLATION <br /> •Aerosols Unit:Thread Aerosolv into 2"bung of drum, <br /> Rotate clockwise until ground support plate firmly <br /> engages drum rim.See lower right side of photo. <br /> o •Filter:Thread directly to 3/4"bung of drum. <br /> ° •Anti-Static Ground Wire:Attach ring terminal of <br /> Anti-Static Wire to brass screw on Aerosolv Ground <br /> Support Plate <br /> •Attach alligator clip of Anti-Static Wire to any nearby <br /> confirmed ground source,ex:metal pipe. <br />