COMPLIANCE INFO_2020 - Laserfiche WebLink

Home Browse Search

USING A REROSOLV® •Wear safety goggles while operating Aerosolv • • Insert aerosol can,NOZZLE END DOWN,into Aerosolv housing sleeve,so that shoulder of can rests on gasket. _ For 1""mini-cans",push shoulder of can beyond gasket. ° Be sure to remove cap from aerosol can prior to insertion. •When puncturing"jumbo"cans,remove white plastic sleeve from Aerosolv housing,then insert can as above. •Lower sliding top plate and FIRMLY engage against plastic sleeve or bottom of"jumbo" can.TIGHTEN lock knob. • Push handle down firmly until completely depressed and hold in place while can releases initial pressure.Slowly raise the handle and immediately depress,this will control the rate of pressure and content evacuation from the aerosol can.In order to prevent back pressure,allow the contents of the can to drain into the collection drum (about 20 seconds). •After removing punctured can,lower sliding top to rest on plastic sleeve to seal collection drum.For"jumbo"cans,replace plastic sleeve prior to lowering sliding top plate. A REROSOLV. FILTER •Replace Activated Carbon Cartridge(upper portion)every 3 months or 750 cans;more frequent change-outs may be necessary based on use.Remove spent Activated Carbon Cartridge by turning counter-clockwise while holding in place Coalescing Cartridge(bottom portion).Replacement of the Activated Carbon Cartridge will prolong the life of the entire Combination Filter. •Replace the entire Combination Filter every 9 months, 2250 cans,or after the Activated Carbon Cartridge(upper portion)is changed-out twice.To replace simply order a Combination Filter,which includes the Coalescing Cartridge and the Activated Carbon Cartridge A REROSOLV. ANTI-STATIC WIRE OSHA requires that liquid storage vessels be grounded to prevent static electricity build-up.The Aerosolv System includes an Anti-Static Wire for user convenience.