ARCHIVED REPORTS_XR0009070 - Laserfiche WebLink

Home Browse Search

l When respirators are being used, they shall be cleaned at the end of the work shift using mild soap and warm water, and left to air dry. After drying, the respirator will be stored in a clean plastic bag. 5.3 Using Personal Protective Equipment All persons entering the EZ shall put on the required PPE in accordance with the requirements of this plan. When leaving the EZ, PPE will be removed in accordance with the procedures listed, in order to minimize the spread of contamination. 5.3.1 Donning Procedures These procedures are mandatory, only if Level C or higher PPE is required for the project: N Remove bulky outerwear. * Put on the required chemical protective coveralls. Put on chemical protective boots. • Tape the legs of the coveralls to the boots with duct tape. • Put on chemical protective gloves. ' Tape the wrists of the protective coveralls to the gloves. • Don respirator if required, and perform appropriate fit check. • Put hood or head covering over head and respirator straps. • Don remaining PPE, such as safety glasses or goggles and hard hat. If these procedures are instituted, one person shall remain outside the work area to ensure that each person entering has the proper protective equipment. No persons shall be allowed to enter an EZ if they are not wearing the required PPE. 5.3.2 Doffing Procedures Whenever a person leaves a Level C or higher work site, the following decontamination sequence will be followed: 1 • Upon enteringthe CRZ rinse contaminated materials s from the boots. • Clean reusable protective equipment. • Remove protective garments, equipment, and respirator. All disposable clothing should be placed in plastic bags, which are labeled with contaminated waste labels. • Wash face and neck. • Proceed to clean area and dress in clean clothing. • Clean and disinfect respirator for neat use. 1 MM5-09-94/UST/94-0064 5-3