ARCHIVED REPORTS_XR0009848 - Laserfiche WebLink

Home Browse Search

• flights, and a coXe was taken from 60' to 62' , recovery consisted of 24" of tan to buff silty clay, dense, firm, with a mottled gray appearance. There was no odor noted, but a PID reading recorded 14 ppm. A sample was sealed and preserved as described earlier. The well was advanced to 70' ; drill cuttings were tan to buff clay as above. ThQ hole was cQr_ed_fxoaL_7Q, to 72' ; recovery consisted of 18" of very fine micaceous silty water sand, buff to tan, with a slight petroleum odor. A reading of 97 ppm was recorded with the PID meter. The bottom tube was sealed and Preserved using standard field procedures. The hole was taken to 81' ; sediments consisted of soft, loose, water sand. EXH [B T Y I is a lithologic plot of the hole. The auger flights were pulled, and the hole enlarged to 10 1/4" for placing the casing. Blank & perforated threaded flush-joint 4" OD, sch. 40 casing was run, sand packed and sealed as shown on schematic diagram EXHIBIT XI . The top of the casing was covered, and operations ceased for the day The preserved • samples were stored under refrigeration for future transfer to the laboratory. May__26,_J 99� -- The rig was moved and spotted on the location marked for MONITORING WELL #2; clean 8 1/4" augers were advanced to 10' ; cutting consisted of black peaty loam and tan to brown clay. A--core was taken from IQ ' to _12' using the same method as described earlier. Recovery was 24" of tan to buff, silty, Plastic clay. No odors or staining were noted, and no PID reading was taken The sample at 11 ' was sealed and preserved The augers were advanced to 20' , drill cuttings were tan to buff, slightly sticky clay. A core was taken from_ 20' to 22' ; .recovery was 24" of tan to buff, silty clay; moist, soft. There was no odor, and the PID meter did not give a positive reading The sample at 21 ' was sealed and preserved per standard protocol . After augering to 301 , a core w s &aken from 30' to_32' ; .recovery was 24" of buff to tan, silty, crumbly clay; slightly moist with a mottled appearance. There were no odors detected, but a reading of 11 ppm was measured with the PID meter. The sample at 31' was sealed and preserved as above Augers were advanced to 40' , and a c re was taken from 40' to 42' ; recovery was 24" of tan to buff, silty micaceous clay as • last above. There was no odor, but the PID meter gave a reading of 12 ppm. The middle tube was sealed and preserved 11