Laserfiche WebLink
10 Multi-Sync Installat& Instructions t J <br /> rDPM For Blueline Small Fittings <br /> This kit provides the Multi-Sync Repair for applications where the pipe is coming thru the <br /> do!A-01V sump wall straight or at an angle. <br /> WARNING:Prepare all surfaces to be bonded prior to completing installation steps below. <br /> MSZ BLS-xx Failure to follow each step will void warranty&may result in premature failure of penetration fitting. <br /> Page 1 This Kit applies for reaairingV` 1 ' )::Blluueline Small Fittings <br /> bzj <br /> General Instructions for: CLEANING:Spray all surfaces to be bonded with DBC Cleaner and allow to air dry or wipe excess with a clean dry <br /> cloth. Surfaces must be dry before applying bonder. Lcx'a 2, - (n5 j��\ <br /> 2- G(A-WAL <br /> STEP 1: Remove Old Boot STEP 2: Clean all Repair Components STEP 3: Place&Dry Fit Insert&Sleeve <br /> • Remove clamps Clean all repair components with DBC Place the split cuff insert over the pipe and test fit to <br /> • Cut away old boot prior to installation inside of the existing fitting cuff. <br /> • Clean&sand fitting Place the split sleeve over the pipe&up to the cuff with <br /> Split Cleaner Split the fill port up <br /> Cuff Sleeve <br /> Insert <br /> Eccentric Insert Multi-Sync <br /> Reducer <br /> =NINE= <br /> STEP 5: Install The Sleeve STEP 6:install&Bond Eccentric Insert&Multi-Sync <br /> • Apply DBB V to outside of cuff. Reducer Back Together <br /> • Position the sleeve with the fill port at the top • Wrack Eccentric Insert around the pipe <br /> • Once you have the sleeve lined up correctly, • Wrack Multi-Sync Reducer around the pipe <br /> slide onto cuff • Apply Zip Tite to split area on Eccentric Insert,press <br /> ends together&clamp <br /> • Apply Zip Tite to split area on Multi-Sync Reducer, <br /> press ends together&clamp <br /> y i y <br /> r Y4lb fr yir� �r �Ff ,ir I Y to y � �'I I��ir,P l� ri1 <br /> STEP 4: Bond Sleeve&Insert <br /> • Apply Zip Tite to split cuff insert. Use 1 of <br /> the clamps to hold in place while curing. <br /> • Apply Zip Tite to the split sleeve and use 2 <br /> clamps to hold in place while curing. <br /> • Leave these clamps in place for approx 30 <br /> minutes for curing before proceeding to <br /> the next step <br /> Set the Clamp the around the sleeve&over the <br /> cuff and tighten"snugly". <br />