Laserfiche WebLink
0 Multi-Sync Installs _ InstructionsJ2 <br /> F6 -Blue ine Small Fittings <br /> This kit provides the Multi-Sync Repair for applications where the pipe is coming thru the <br /> sump wall straight or at an angle. <br /> WARNING:.Prepare all surfaces to be bonded prior to completing installation steps below. <br /> MSZ BLS•xx Failure to follow each step will void warranty&may result In premature failure of penetration fitting. <br /> Page 1 This Kit applies for repairin <br /> ++g <br /> :Blueline Small fittings <br /> _ .. V. -_ .. _. __`. <br /> General Instructions for: CLEANING:Spray all surfaces to be bonded with DBC Cleaner and allow to air dry or wipe excess with a clean dry <br /> cloth. Surfaces must be dry before applying bonder. <br /> STEP 1: Remove Old Boot STEP 2: Clean all Repair Components STEP 3: Place&Dry Fit Insert&Sleeve <br /> • Remove clamps Clean all repair components with DBC • Place the split cuff insert over the pipe and test fit to <br /> • Cut away old boot prior to installation inside of the existing fitting cuff. <br /> • • Place the split sleeve over the pipe&up to the cuff with <br /> Clean&sand fitting Split Cleaner Split the fill port up <br /> j Cuff Sleeve <br /> Insert <br /> Eccentric Insert Multi-Sync <br /> M Reducer <br /> i STEPS: Install The Sleeve STEP 6:Install&Bond Eccentric Insert&Multl-Sync <br /> r <br /> Apply DBB V to outside;of cuff. Reducer Back Together <br /> i Position the sleeve with the fill port at the top • Wrack Eccentric Insert around the pipe <br /> • Once you have the sleeve lined up correctly, • Wrack Multi-Sync Reducer around the pipe <br /> slide onto cuff • Apply Zip Tite to split area on Eccentric Insert,press <br /> ends together&clamp <br /> • Apply Zip Tite to split area on Multi-Sync Reducer, <br /> press ends together&clamp <br /> STEP 4: Bond Sleeve&Insert <br /> • Apply Zip Tite to split cuff insert. Use 1 of <br /> the clamps to hold in place while curing. <br /> • Apply Zip Tite to the split sleeve and use 2 <br /> clamps to hold In place while curing. <br /> • Leave these clamps in place for approx 30 <br /> minutes for curing before proceeding to <br /> the next step <br /> ___-- <br /> Set the Clamp the around the sleeve&over the <br /> _ - cuff and-tighten"`snugly". <br />