COMPLIANCE INFO_2011-2015 - Laserfiche WebLink

Home Browse Search

Single -Wall • Ent*Termination+ 5. Place one ring over the sump fitting in the inside of the sump and rotate to the desired angle. Make alignment mark on both the sump wall and the ring. 6. Mix one 7014 or 8014 adhesive kit for each fitting per the instructions in the adhesive kit. Mix in filler to thicken adhesive (fiberglass alignment ring will not seal properly without filler). 7. Apply adhesive generously, appro- ximately Vie thick to the inside and the outside of the sump walls where the alignment rings are located. Coat cut edges of the entry hole. Apply a thin coating of adhesive to all three alignment rings. 8. Line up rings with alignment marks and press together firmly. 9. Slide the metal retaining ring over inside section of sump fitting against the alignment ring until tight against sump wall. A short section of pipe (3" pipe for 2" fitting, 4" pipe for 3" fitting; contact manufacturer for 4" fitting) may be used to drive the metal retaining ring over the fitting. Be sure there is an adhesive bead visible between the rings and the sump wall. The metal ring must hold the assembly in position while the adhesive cures. If the assembly is not tight against the sump wall, firmly press the entry fitting against the outside sump wall while pressing the metal ring against the alignment ring on the inside. 10. Do not disturb assembly until the adhesive is cured. Clean excess adhesive from all bonding surfaces. See adhesive kit instructions for cure times. 11. The use of an industrial hot air gun may speed up the curing process. Do not overheat. EDILE ROCK, AR SAtiC7 SPRINGS, OK: MEMBER aff NTf v i racerriarK or varco 11P, Inc. FIBER GLASS SYSTEMS - A NATIONAL OILWELL VARCO COMPANY www.smithfibercast.com 2700 W. 65th ST., LITTLE ROCK, AR 72209 -501-568-4010 - FAX 501-568-4465 Printed USA 2.5M1206 25 S. MAIN ST., SAND SPRINGS, OK 74063 -918-245-6651 - FAX 918-245-7566