COMPLIANCE INFO_2006-2008 - Laserfiche WebLink

Home Browse Search

Bonding primary The table indicates the adhesive pot life under various temperature conditions.In hot Systems(cont.) weather,pot life may be extended by wrapping a damp rag around the can of mixed adhesive or by spreading the adhesive on aluminum foil to dissipate the heat. Pot life/cure times for Ameron PSX•20 adhesive Minimum Ambient Adhesive Minimum Joint Temperature Pot Life Cure Time` (°F) (°C) (minutes) (hours) 40 5 70 12 65 18 40 5 75 24 30 4 95 35 20 3 ` Cumulative totals.Cure time at listed temperatures need not be uninterrupted,but total time must equal the tabulated time before Force curing adhesive r , At temperatures below 50°F(10°C)or if the temperature will not be above 50°F(10°C) Temperatures may be lower ' during the entire period of cure,an external heat source must be used to force cure the in a trench or out of direct 1 adhesive.The adhesive and the bonding surfaces should be warmed to 50°F(10°C) sunlight. 1 before mixing and applying the adhesive. L----------J Below 50°F(10°C)force cure the adhesive with an external heat source such as: • Chem Cure Pak(US Pat.No.3,475,239) • Ameron heating blanket sufficiently large to cover the joint • Forced air heater ifthe trench is covered to contain the heat • Hotairgun Using Chem Cure Pak with Ameron PSX•20 adhesive The Chem Cure Pak is a self-contained,nonelectrical heat source for curing adhesive- bonded joints.Instructions are printed on the Pak wrapper.The Pak is designed so that sufficient heat is generated to cure Ameron PSX•20 adhesive in one hour at ambient temperatures as low as 0°F(-18°C).The Chem Cure Pak is manufactured in different sizes corresponding to the diameter ofthe piping being installed.Use the correct size Pak for your installation.Refer to table on page 11 when ordering. In cold weather,wrap insulation around the Pak as soon as it has stopped steaming.For lower temperatures or when installing extra-heavy fittings,consult Ameron for specific r————————————1 recommendations. I Chem Cure Pak contains oxalic 1 • Assemble pipe and fittings using standard field installation procedures. I acid.Harmful if swallowed.Causes 1 . Mix the chemicals thoroughly as directed on the Pak wrapper. I skin and eye irritation. 1 ®®®®®®®®®®®®J • Wrap the Pak around the connections,centering it overthe tapered section ofthe joint,not over the end ofthe fitting.Cover the entire bonding area to which adhesive has been applied.Refer to Fig.7-1. • Use one Pak per bond:sleeve couplings in 3-inch sizes and larger require two Activator Paks.However,a single Pak is sufficient for curing both bonds in a 2-inch sleeve 1-inslot syringe Coupling. • Secure the Pak with tie wires. • Cut one slit at least 1 inch wide(25 mm)on each upper side ofthe Pak. • Inject water into the slits with the activator syringe-approximately one half into Tie wires each side Center Pak over Aluminum foil may be wrapped directly overthejoint to prevent the Pak from tapered area sticking if it is necessary that the expended Pak be removed from the trench. Fig.7-1.The Chem Cure Pak should Follow the precautions printed on the Chem Cure Pak wrapper: produce steam in about 30 seconds after injecting water./fno reaction occurs, Do not get ingredients on skin,in eyes,or on clothing. discard the Pak and use another one. Do not breathe dust or vapor. • Use only outdoors where adequate ventilation is provided. • Do not take internally. • Keep out of reach of children. 10