Laserfiche WebLink
JUN 11 2000 6:17AM HP LASERJET 3200 <br />;I <br />ii <br />p.4 <br />STEP b Apply a bead of Blue Seal Glue along ft gasket rim and install <br />the boot onto the seal. Install boot w10 fill tube at the 12:00 <br />position. Install band clamp to secure tho boot to the gasket. <br />STEP 7 Position the insert into the boot if applitlable, but do not tighten <br />the clamp. This connection must remain lloose through the filling <br />stage to allow air to escape. <br />STEP 8 Fill the boot with either Parasealant 426, or Bostik I100FS <br />through the fill tube with the Blueline p*eumatic dispensing gun <br />until the entire cavity is full. This willipusure that the sealant <br />pushes back through the leak point and stops the leak. <br />STEP 9 Once the boot is full, tighten clamps aq{1 allow sealant to fully <br />cure. <br />'I <br />