Laserfiche WebLink
J <br />D. Alternate construction for new underground storage tanks containing motor vehicles fuel [Section 26333. <br />(1) Monitoring and response plan [Section 26341. <br />(2) Underground storage tank composed of.... <br />® (a) Fiberglass reinforced plastic. <br />(b) Cathodically protected steel. <br />— (c) Steel clad with fiberglass reinforced plastic. <br />® (d) Other material that complies with section 2631 and 2632. <br />(3) Floor of teak interception and detection system constructed on a firm base and sloped to a <br />collection sump (use of membrane liners comply with section 2631 (d) (6) requirements.) <br />(4) Access casings installed in the collection sump of the secondary containment system with <br />backfill in the interstitial space. The access casing shall meet all of the following: <br />® Designed and installed to allow the liquid to flow into the casing.. <br />Sized to allow removal of collected liquid and able to withstand all anticipated applied <br />stresses. <br />Constructed of material that will not be structurally weakened. <br />® Screened along entire vertical zone of permeable material. <br />Capable of preventing leakage of any hazardous substance from the casing. _ <br />® Extend to the ground surface and covered with a locked waterproof cap. <br />e Capable of meeting S.J. Co. PNS -END Well Standards. <br />Leak interception and detection system shalt prevent the leaked hazardous substance from <br />entering ground water. <br />14. INTERSTITIAL SPACE MONITORING <br />A. Visual monitoring [Section 2632 (c) (1)] <br />(a) Exterior surface and floor beneath tank monitored by direct viewing <br />(b) Daily visual inspections <br />(c) Liquid level in tank to be recorded at time of inspection <br />(d) If liquid observed around or beneath primary tank, owner wilt determine if an unauthorized release <br />has occurred. <br />B. Mechanical or electronic monitoring [Section 2632 (c) (2)] <br />(a) Continuous monitoring system connected to an audible and visual alarm system. <br />Monitoring equipment to be installed <br />ILManufacturer:jZ (Nl 1 <br />Model Number: 7 L 5 50 <br />Sensor Type: Vapor 4 Liquid � Both. <br />Sensor/Panel specifications. <br />Location(s) for sensors: <br />Tank: A�\p\l Piping: S m.�. -:, <br />Dispenser: <br />C. Monitoring and response plan submitted [Section 2632 (d) (1) & (2)]. <br />15• Any special accessories, fittings, coatings, or linings not inherent within the initial design of the 10 tank or <br />double -watt UST. [Section 2631 (b)] <br />A. Approved by a nationally recognized independent testing organization. <br />B. Demonstration of integrity with the primary and/or secondary containment. <br />G <br />